StarTech.com USBDUP15 manual Whole Media, Button Beep, Asyn Hold time, Target Tolerance, Language

Page 15
7.2.2 Whole Media

7.2.2 Whole Media

Set the system to copy the entire Flash drive’s content, including empty space and file format.

7.3 Button Beep

Turn audio feedback ON/OFF. ON by default.

7.4 Asyn Hold time

Set the time to cancel an Asynchronous copy when you’ve temporarily finished copying and all of the Flash drive devices have been removed, but the copy job has not been manually cancelled. This is to prevent mistakenly overwriting your source drive when you’d like to start a new source copy but the previous Asynchronous copy job has not yet been cancelled.

The default is 30 seconds. When the system no longer detects any Flash drive for 30 seconds, the system will prompt you to either exit or keep the current copy job.

7.5 Target Tolerance

Set the tolerance of the capacity gap between the source and destination ports in %. There are three modes, with the default being ‘no limit’, as follows:

a)Allow Tolerance: Users can set the high and low limit (%) of capacity difference between the source and destination drive separately.

b)No Limit: Users can disable the capacity limit between the source and destination drive. If the data on the source drive is larger than the capacity of the destination drive, this will lead to an incomplete/failed duplication.

c)100% same: Users can set the capacity of the destination drives to be the exact same as the source drive. If the sizes do not match, the duplication will not start.

7.6 Asynchronous Mode

Choose to disable or enable Asynchronous copy mode. If enabled and the data on the source is smaller than the system’s buffer memory, it will automatically use asynchronous when copying. If disabled, the system will copy in synchronous mode.

This mode is enabled by default.

7.7 Check before Copy

Choose to enable or disable the system checking the Flash drive before starting a copy. By default, the drive is not checked before copying.

7.8 Power off time between Copy + Compare

When performing the Copy + Compare function, set the wait time (in seconds) after a Copy has completed, and before the Compare starts. The default is 3 seconds.

7.9 Language

Change the system language between English and Japanese.

Instruction Manual

12

Image 15
Contents FR Guide de lutilisateur - fr.startech.com 2m Mobile Charge Sync Micro USB Cable - A to Micro BUSBDUP15 DE Bedienungsanleitung - de.startech.comConsult the dealer or an experienced radio/TV technician for help FCC Compliance StatementReorient or relocate the receiving antenna Increase the separation between the equipment and receiverIntroduction Product DiagramHardware Setup Warranty InformationProduct Diagram Top ViewBack View Packaging Contents IntroductionSystem Requirements Hardware Setup User Menu Table of Contents Hardware Operation 1. Copy1.1 Synchronous Copy Operating Process 1.2 Asynchronous CopyAutomatically compares the Flash drive once the copy has completed 2. Compare3. Copy + Compare flashing and when there is an error red LED solid4. Capacity Check 5. Information5.1 USB Info 6.1.2 FAT Format 6. Utility5.2 System Information 6.1 Do Format6.3.1 H3 Safe 100% 6.3.3 Setup Range6.2 Measure Speed 6.3 Media Check6.4 Quick Erase 7. Setup6.3.4 Setup Error Limit 6.7 System Update7.4 Asyn Hold time 7.8 Power off time between Copy + Compare7.2.2 Whole Media 7.3 Button BeepNormal Mode default setting Faster Mode Fastest Mode 7.12 Restore Default7.10 Working Mode 7.11 Set HDD ModeWarranty Information Technical SupportLimitation of Liability Hard-to-find made easy. At StarTech.com, that isn’t a slogan. It’s a promise