StarTech.com USBDUP15 manual Asynchronous Copy, Operating Process

Page 9
1.2 Asynchronous Copy

3.When the copy has completed, the LCD display will show the total time it took to copy, the number of passes, and if there were any failures.

NOTE:

a)When the copy is in progress, the green LED will flash for each Flash drive that is connected. When the copy has finished, the green LED will stop flashing and remain illuminated. If an error occurs, the red LED will illuminate.

b)Do NOT remove the Flash drives while the system is copying (green LED is flashing). You can cancel duplication by pressing ESC.

c)It is recommended that the source and destination are the same size. Copying to or from a larger Flash drive may cause an error and the copy will fail.

d)If copying a Flash drive with NTFS or Linux file formats, the destination capacity MUST BE equal or larger than the source’s capacity.

1.2 Asynchronous Copy

NOTE: This mode is enabled by default. The source’s content size must be smaller than the system’s buffer memory, otherwise the system will automatically duplicate in Synchronous mode.

To enable Asynchronous mode, go to function “7.6 Asynchronous”, and select “Enable”.

Operating Process

1.Plug in the source Flash drive, and press OK. The system will start to read the source’s content into the system’s buffer. Once completed, it will immediately start to copy once a destination Flash drive has been plugged in.

Instruction Manual

6

Image 9
Contents USBDUP15 2m Mobile Charge Sync Micro USB Cable - A to Micro BDE Bedienungsanleitung - de.startech.com FR Guide de lutilisateur - fr.startech.comReorient or relocate the receiving antenna FCC Compliance StatementIncrease the separation between the equipment and receiver Consult the dealer or an experienced radio/TV technician for helpHardware Setup Product DiagramWarranty Information IntroductionProduct Diagram Top ViewBack View Packaging Contents IntroductionSystem Requirements Hardware Setup User Menu Table of Contents Hardware Operation 1. Copy1.1 Synchronous Copy Operating Process 1.2 Asynchronous Copy3. Copy + Compare 2. Compareflashing and when there is an error red LED solid Automatically compares the Flash drive once the copy has completed4. Capacity Check 5. Information5.1 USB Info 5.2 System Information 6. Utility6.1 Do Format 6.1.2 FAT Format6.2 Measure Speed 6.3.3 Setup Range6.3 Media Check 6.3.1 H3 Safe 100%6.3.4 Setup Error Limit 7. Setup6.7 System Update 6.4 Quick Erase7.2.2 Whole Media 7.8 Power off time between Copy + Compare7.3 Button Beep 7.4 Asyn Hold time7.10 Working Mode 7.12 Restore Default7.11 Set HDD Mode Normal Mode default setting Faster Mode Fastest ModeWarranty Information Technical SupportLimitation of Liability Hard-to-find made easy. At StarTech.com, that isn’t a slogan. It’s a promise