Tripp Lite UL1778 owner manual Connect your UPS to An electrical outlet, Select UPS Operating Mode

200208108 93-2089 OmniSmart725 Owner’s Manual.qxd 9/12/2002 9:22 AM Page 3

Quick Installation

1Connect your UPS to

an electrical outlet.

Your UPS will run a self-test after it is plugged in. See Basic Operation to understand the results of its self-test.

2Plug your computer, monitor and external modem into

UPS/Surge outlets.

Your UPS is designed to support only computer equipment. You will overload your UPS if you connect high power draw equipment such as household appliances, laser printers or surge suppressors to its UPS/Surge outlets.

Select models only:“Surge-only” receptacles (identified on the back of the UPS) are used to provide peripherals with surge protection without committing precious battery power to support them during blackouts.

3Select UPS Operating Mode.*

Press the ON/OFF button to toggle your UPS between the UPS (“ ” LED lit) and the CHARGE ONLY (“ ” LED flashing) modes. Choose the operating mode based on your location:

USA, Canada & Western Europe:

•Leave the UPS in the UPS mode at all times. All Other Countries:

•Put the UPS in the CHARGE ONLY mode when you are not using connected

equipment.

(WARNING! When set to “CHARGE ONLY,” the UPS will not provide battery backup during a blackout or brownout)

•Put the UPS in the UPS mode when you are using connected equipment.

*See Basic Operation section for a complete explanation of each mode.

1

NORM DELAY

2

3

3