ConneXium™ Ethernet Gateway | |
2/2006 | Setup |
|
|
SNMP Parameters | The ETG supports SNMP, allowing a network administrator to remotely | ||
| access an ETG with an SNMP manager and view the networking status and | ||
| diagnostics in the MIB2 format. |
| |
|
|
|
|
|
| Action | Result |
|
|
|
|
| 1. | From the Setup page, click SNMP | Opens the SNMP Parameters page. |
|
| Parameters. |
|
|
|
|
|
| 2. | Check Enable SNMP to turn ON the simple | Activates SNMP. |
|
| network management protocol. |
|
|
| NOTE: If you uncheck Enable SNMP and |
|
|
| click Apply, the ETG will reboot and SNMP |
|
|
| functionality will be turned OFF. |
|
|
|
|
|
| 3. | Enter the system contact, system name, | Enters the SNMP system information and |
|
| system location, | community access names. |
|
| name, and the |
|
|
|
|
|
| 4. | Click Apply. | Saves the SNMP settings. |
|
|
|
|
Figure 11: SNMP Parameters Page
ENGLISH
© 2006 Schneider Electric. All Rights Reserved. | 13 |