Schneider Electric TSXETG100 Accessing the ETG Over a Network, Additional Resources, Logging Out

Page 3

63230-319-211A1

ConneXiumEthernet Gateway

2/2006

Accessing the ETG Over a Network

 

 

Additional Resources

ACCESSING THE ETG OVER A NETWORK

Logging into the ETG

Documentation and Firmware: Go to www.telemecanique.com, select Products > Products index > Systems and architectures > Connexium.

After you set up the Ethernet parameters (see the installation guide), you can access the ETG over an Ethernet LAN using Internet Explorer 6.0 or higher.

 

Action

Result

 

 

 

1.

Launch Internet Explorer 6.0 or higher.

Opens Internet Explorer.

 

 

 

2.

In the Address text box, type the address

Opens the Login dialog box.

 

of your ETG (169.254.0.10 is the default),

 

 

then press Enter.

 

 

 

 

3.

Type your user name (Administrator is the

Enters the user name and password, then

 

default) and password (Gateway is the

opens the ETG home page.

 

default) into the text boxes, then click OK.

 

 

 

 

4.

Click Setup to access the ETG setup page,

Opens the Setup or Diagnostics pages.

 

or click Diagnostics to access the ETG

 

 

diagnostics page.

 

 

 

 

ENGLISH

Figure 1: The ETG Home Page

Menu bar

Logging Out

We recommend logging out whenever you do not need access to the ETG.

 

To log out of the ETG configuration session, click Log Out to end your

 

session.

© 2006 Schneider Electric. All Rights Reserved.

3

Image 3
Contents ConneXium Ethernet Gateway TSXETG100 Table of ContentsHardware Address Resolution Protocol ARP ARP is used to convert IPIntroduction Supported Ethernet ProtocolsLogging Out Accessing the ETG Over a NetworkAdditional Resources Logging into the ETGETG static web pages SetupDiagnostics ETG User Interface OverviewOption Description Setting SetupEthernet and TCP/IP Settings 63230-319-211A1 ConneXium Ethernet Gateway 2006 SetupDuplicate IP Detection Scenarios ConneXium Ethernet Gateway 63230-319-211A1 Setup 2006Scenario Duplicate IP Detected Power/Status LED Duplicate IP Address DetectionDefault 3 seconds 2006 SetupDefault Master Default EvenBefore you begin, keep in mind the following For master mode usage of the COM portMaster Mode Device List Setup Master Mode Topology Device ListRS485 Slave Mode Device List SetupSlave Mode Topology Ethernet Connection ETGUser Accounts ETG accounts and passwordsConneXium Ethernet Gateway Setup Account Default PasswordAccess Web Page AccessGroup Access Group AccessModbus TCP/IP Filtering TCP/IP Filtering Check Enable FilteringParameters Snmp ParametersMenu bar DiagnosticsConneXium Ethernet Gateway 63230-319-211A1 Diagnostics 2006 StatisticsEthernet 2006 DiagnosticsInterpreting Statistics Statistic DescriptionConneXium Ethernet Gateway Diagnostics Serial PortGateway Information ETG Read Device Register Settings Option Description DefaultRead Device Registers Updating the Firmware File FirmwareFinding the Firmware Version Getting New FirmwareDeutsch
Related manuals
Manual 2 pages 58.14 Kb