Schneider Electric TSXETG100 manual Device List, Before you begin, keep in mind the following

Page 8

ENGLISH

ConneXiumEthernet Gateway

63230-319-211A1

Setup

2/2006

 

 

Device List

Before you begin, keep in mind the following:

 

For master mode usage of the COM port:

 

Modbus devices do not have to be defined in the Device List, but it helps

 

you manage your system.

Master Mode Device List Setup

Figure 4:

Master Mode Topology

 

 

Ethernet

 

 

Connection

 

 

ETG in

 

 

master

 

 

mode

 

RS485 connection

Up to 128 serial

 

 

slave devices

 

 

using repeaters

 

Serial Slave Devices

 

If you selected Master mode on the Serial Port page, follow the steps below to set up the device list:

 

Action

Result

 

 

 

1.

From the Setup page, click Device List.

Opens the Device List page.

 

 

 

2.

Select the number of viewable devices (1 to

Selects the number of viewable locations that

 

128), then click Apply.

can be used to define serial slave devices

 

 

connected to the ETG.

 

 

 

3.

In the Local ID text box, type the local ID

Enters the local address of the device.

 

(address) of the serial slave device.

 

 

 

 

4.

Repeat step 3 until all of the devices are

Enters all of the connected devices.

 

entered.

 

 

 

 

5.

Click Apply.

Updates the Device List settings.

 

 

 

Figure 5: Device List Page in Master Mode

8

© 2006 Schneider Electric. All Rights Reserved.

Image 8
Contents Table of Contents ConneXium Ethernet Gateway TSXETG100Address Resolution Protocol ARP ARP is used to convert IP IntroductionSupported Ethernet Protocols HardwareAccessing the ETG Over a Network Additional ResourcesLogging into the ETG Logging OutSetup DiagnosticsETG User Interface Overview ETG static web pagesSetup Ethernet and TCP/IP Settings63230-319-211A1 ConneXium Ethernet Gateway 2006 Setup Option Description SettingConneXium Ethernet Gateway 63230-319-211A1 Setup 2006 Scenario Duplicate IP Detected Power/Status LEDDuplicate IP Address Detection Duplicate IP Detection Scenarios2006 Setup Default MasterDefault Even Default 3 secondsFor master mode usage of the COM port Master Mode Device List Setup Master Mode TopologyDevice List Before you begin, keep in mind the followingSlave Mode Device List Setup Slave Mode TopologyEthernet Connection ETG RS485ETG accounts and passwords ConneXium Ethernet Gateway SetupAccount Default Password User AccountsWeb Page Access Group AccessGroup Access AccessTCP/IP Filtering Check Enable Filtering Modbus TCP/IP FilteringSnmp Parameters ParametersDiagnostics ConneXium Ethernet Gateway 63230-319-211A1 Diagnostics 2006Statistics Menu bar2006 Diagnostics Interpreting StatisticsStatistic Description EthernetGateway Information ConneXium Ethernet Gateway DiagnosticsSerial Port Read Device Registers ETG Read Device Register SettingsOption Description Default Firmware Finding the Firmware VersionGetting New Firmware Updating the Firmware FileDeutsch
Related manuals
Manual 2 pages 58.14 Kb