Pelco Dx8000 manual Disconnect the Data Cable and Power Wire, Removing IDE Data Cables

Page 12

Disconnect the Data Cable and Power Wire

When removing the data cable and power wires, pull the connectors straight out. Do not rock connectors back and forth or remove a connector by pulling it by its wires or cable.

1.Remove the IDE data cable from the hard drive, CD-RW drive, and motherboard:

a.Carefully pull the plastic tab of each cable connector away from the hard drive and CD-RW drive. Refer to Figure 8.

b.Following the same procedure, remove the other end of each IDE cable from the drive interface connector on the motherboard. Refer to Figure 8.

HARD DRIVE 1a

IDE CONNECTOR

CD-RW

IDE CONNECTOR 1a

MOTHERBOARD 1b

IDE CONNECTOR

Figure 8. Removing IDE Data Cables

10	C1607M (6/04)

Image 12

Contents DX8000 Page Parts List IntroductionTools Needed Removing Power Cord from Wall Getting ReadyRemoving Power Cord from Unit ESD Protection Preparing Unit for Drive Installation Open the Unit ChassisRemoving Chassis Cover Component Layout DX8000 InteriorMove the Front Cross-Brace Removing Front Cross-BracePlacing Front Cross-Brace Across Rear of Unit Disconnect the Data Cable and Power Wire Removing IDE Data CablesRemoving Hard Drive Power Connection Remove the Drive Mount Baskets Removing Hard Drive BasketInstall an Additional Drive Prepare the DrivesMount the Additional Drive Inserting Drives into BasketReplacing Drive Basket SET the Master / Slave Jumpers Setting Drive Jumpers Reconnect the Data and Power Cables Installing CD-RW Data CableInstall Hard Drive Data Cables Installing Hard Drive Power Connectors Reassemble the Unit Replacing Front Cross-BraceReplacing Chassis Cover Restarting Unit Preparing the New Drives to Store Data Opening List of DrivesSelecting Allocation Option for Each Drive Format Warning Dialog Box C1607M 6/04 C1607M 6/04 Product Warranty and Return Information ISO9001

Related manuals

Manual 36 pages 35.01 Kb

Manual 10 pages 26.21 Kb

Manual 40 pages 3.7 Kb

Manual 1 pages 21.57 Kb