Pelco Dx8000 manual Move the Front Cross-Brace, Removing Front Cross-Brace

Page 10

Move the Front Cross-Brace

1.Unscrew and lift out the front cross-brace (found at the center of the unit). Moving this part out of the way will make it easier for you to access the hard drive mounting baskets.

a.Use a Phillips-head screwdriver to remove the two flat-head screws that secure the front cross-brace. Refer to Figure 6.

Figure 6. Removing Front Cross-Brace

8

C1607M (6/04)

Page 9 Page 11
Image 10
Page 9 Page 11
Contents DX8000 Page Introduction Parts ListTools Needed Removing Power Cord from Wall Getting ReadyRemoving Power Cord from Unit ESD Protection Preparing Unit for Drive Installation Open the Unit ChassisRemoving Chassis Cover Component Layout DX8000 InteriorMove the Front Cross-Brace Removing Front Cross-BracePlacing Front Cross-Brace Across Rear of Unit Disconnect the Data Cable and Power Wire Removing IDE Data CablesRemoving Hard Drive Power Connection Remove the Drive Mount Baskets Removing Hard Drive BasketInstall an Additional Drive Prepare the DrivesMount the Additional Drive Inserting Drives into BasketReplacing Drive Basket SET the Master / Slave Jumpers Setting Drive Jumpers Reconnect the Data and Power Cables Installing CD-RW Data CableInstall Hard Drive Data Cables Installing Hard Drive Power Connectors Reassemble the Unit Replacing Front Cross-BraceReplacing Chassis Cover Restarting Unit Preparing the New Drives to Store Data Opening List of DrivesSelecting Allocation Option for Each Drive Format Warning Dialog Box C1607M 6/04 C1607M 6/04 Product Warranty and Return Information ISO9001
Related manuals
Manual 36 pages 35.01 Kb Manual 10 pages 26.21 Kb Manual 40 pages 3.7 Kb Manual 1 pages 21.57 Kb
Top Page Image Contents