Pelco Dx8000 manual Mount the Additional Drive, Inserting Drives into Basket

Page 16

MOUNT THE ADDITIONAL DRIVE

1.Mount Hard Disk 2 adjacent to Hard Disk 1 in the drive basket closest to the CD-RW drive. Refer to Figure 12 below.

a.Make sure the drive is mounted in the basket so that access to the connectors is not blocked.

b.Attach the drive to the basket using the two screws that came with the upgrade kit.

c.Tighten the screws securely but do not over-tighten.

Figure 12. Inserting Drives into Basket

14	C1607M (6/04)

Image 16

Contents DX8000 Page Introduction Parts ListTools Needed Removing Power Cord from Wall Getting ReadyRemoving Power Cord from Unit ESD Protection Preparing Unit for Drive Installation Open the Unit ChassisRemoving Chassis Cover Component Layout DX8000 InteriorMove the Front Cross-Brace Removing Front Cross-BracePlacing Front Cross-Brace Across Rear of Unit Disconnect the Data Cable and Power Wire Removing IDE Data Cables Removing Hard Drive Power Connection Remove the Drive Mount Baskets Removing Hard Drive BasketInstall an Additional Drive Prepare the DrivesMount the Additional Drive Inserting Drives into BasketReplacing Drive Basket SET the Master / Slave Jumpers Setting Drive Jumpers Reconnect the Data and Power Cables Installing CD-RW Data CableInstall Hard Drive Data Cables Installing Hard Drive Power Connectors Reassemble the Unit Replacing Front Cross-BraceReplacing Chassis Cover Restarting Unit Preparing the New Drives to Store Data Opening List of DrivesSelecting Allocation Option for Each Drive Format Warning Dialog Box C1607M 6/04 C1607M 6/04 Product Warranty and Return Information ISO9001

Related manuals

Manual 36 pages 35.01 Kb

Manual 10 pages 26.21 Kb

Manual 40 pages 3.7 Kb

Manual 1 pages 21.57 Kb