Pelco manual Mounting the SX8205R Module Using the Wall Clip

Page 13

Mounting the SX8205R Module Using the Wall Clip

NOTE: Before mounting the SX8205R module to a wall, ensure that there is adequate space at both ends for viewing the front-panel Power LED and for making the various rear-panel cable connections.

To attach the SX8205R module to a wall using the supplied wall clip, refer to Figure 5 and do the following:

1.Using the two vertical or horizontal wall-mounting holes, attach the wall clip to a wall using two screws (not provided).

2.Slide the module into the clip until the two holes on the bottom of the module align with the two holes on the lower flange of the clip.

3.Attach the module to the clip using the two Phillips pan head screws provided for the clip.

UPPER

FLANGE

VERTICAL

MOUNTING HOLE (2)

HORIZONTAL

MOUNTING HOLE (2)

SCREW, PHILLIPS	LOWER
SCREW, PHILLIPS	FLANGE
PAN HEAD WITH	WALL CLIP
PAN HEAD WITH
LOCK WASHER (2)

Figure 5. Mounting the SX8205R Module Using the Wall Clip

C2626M (2/07)

13

Image 13

Contents Ethernet Switch List of Illustrations ContentsList of Tables Important Safety Instructions Risk of Electric Shock Do not Open Radio and Television Interference Regulatory NoticesDescription Product OverviewRack mount chassis ModelsIllustrates the front panel of the SX8205R module Front Panel of SX8205R Module Reset Button Restarts the unitIllustrates the rear panel of the SX8205R module Rear PanelPackage Contents InstallationFlow control is disabled by default Autonegotiation is enabled by defaultTable A. TX Mode Switch Settings Flow control default settingMounting the SX8205R Module Into a Rack MountingMounting the SX8205R Module Using the Wall Clip 10BASE-T/100BASE-TX connections ConnectionsTroubleshooting Desired, refer to Setting Table C. Troubleshooting with Rear-Panel IndicatorsAmber 10BASE-T link is If 10BASE-T operation is Established 10 for informationNot lit 10BASE-T or Setting of the remoteDo any of the following as 100BASE-TX link Cable Applicable Cannot beDuplex mode Link Duplex modeIf half-duplex mode is Amber Port is set to If 10BASE-T full-duplexFlashing green Port is set to Green Port is set to If 100BASE-TX full-duplex100BASE-TX half Replace cable if it isTable C. Troubleshooting with Rear-Panel Indicators Link/activity and speed, duplex/collision and speed SpecificationsIllustrates RJ-45 MDI/MDI-X connector pinouts Appendix. RJ-45 Connector PinoutsProduct Warranty and Return Information ISO9001