Pelco SX8205R manual Ethernet Switch

Page 1

I N S T A L L A T I O N

	SX8205R Unmanaged
®	Ethernet Switch

Five 10BASE-T/100BASE-TX Ports

C2626M (2/07)

Image 1

Contents Ethernet Switch List of Illustrations ContentsList of Tables Important Safety Instructions Risk of Electric Shock Do not Open Radio and Television Interference Regulatory NoticesDescription Product OverviewRack mount chassis ModelsIllustrates the front panel of the SX8205R module Front Panel of SX8205R Module Reset Button Restarts the unitIllustrates the rear panel of the SX8205R module Rear PanelPackage Contents InstallationFlow control is disabled by default Autonegotiation is enabled by defaultTable A. TX Mode Switch Settings Flow control default settingMounting the SX8205R Module Into a Rack MountingMounting the SX8205R Module Using the Wall Clip 10BASE-T/100BASE-TX connections ConnectionsTroubleshooting Desired, refer to Setting Table C. Troubleshooting with Rear-Panel IndicatorsAmber 10BASE-T link is If 10BASE-T operation is Established 10 for informationNot lit 10BASE-T or Setting of the remoteDo any of the following as 100BASE-TX link Cable Applicable Cannot beDuplex mode Link Duplex modeIf half-duplex mode is Amber Port is set to If 10BASE-T full-duplexFlashing green Port is set to Green Port is set to If 100BASE-TX full-duplex100BASE-TX half Replace cable if it isTable C. Troubleshooting with Rear-Panel Indicators Link/activity and speed, duplex/collision and speed SpecificationsIllustrates RJ-45 MDI/MDI-X connector pinouts Appendix. RJ-45 Connector PinoutsProduct Warranty and Return Information ISO9001