Pelco SX8205R manual Regulatory Notices, Radio and Television Interference

Page 5

Regulatory Notices

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

RADIO AND TELEVISION INTERFERENCE

This equipment has been tested and found to comply with the limits of a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Changes and Modifications not expressly approved by the manufacturer or registrant of this equipment can void your authority to operate this equipment under Federal Communications Commission’s rules.

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.

C2626M (2/07)

5

Image 5
Contents Ethernet Switch List of Tables ContentsList of Illustrations Important Safety Instructions Risk of Electric Shock Do not Open Radio and Television Interference Regulatory NoticesDescription Product OverviewRack mount chassis ModelsIllustrates the front panel of the SX8205R module Front Panel of SX8205R Module Reset Button Restarts the unitIllustrates the rear panel of the SX8205R module Rear PanelPackage Contents InstallationFlow control is disabled by default Autonegotiation is enabled by defaultTable A. TX Mode Switch Settings Flow control default settingMounting the SX8205R Module Into a Rack MountingMounting the SX8205R Module Using the Wall Clip 10BASE-T/100BASE-TX connections ConnectionsTroubleshooting Desired, refer to Setting Table C. Troubleshooting with Rear-Panel IndicatorsAmber 10BASE-T link is If 10BASE-T operation is Established 10 for informationNot lit 10BASE-T or Setting of the remoteDo any of the following as 100BASE-TX link Cable Applicable Cannot beDuplex mode Link Duplex modeIf half-duplex mode is Amber Port is set to If 10BASE-T full-duplexFlashing green Port is set to Green Port is set to If 100BASE-TX full-duplex100BASE-TX half Replace cable if it isTable C. Troubleshooting with Rear-Panel Indicators Link/activity and speed, duplex/collision and speed SpecificationsIllustrates RJ-45 MDI/MDI-X connector pinouts Appendix. RJ-45 Connector PinoutsProduct Warranty and Return Information ISO9001