Pelco SX8205R Table C. Troubleshooting with Rear-Panel Indicators, Desired, refer to Setting

Page 16

Table C. Troubleshooting with Rear-Panel Indicators

Indicator Color	Meaning	Possible Cause	Corrective Action

RJ-45 10BASE-T/100BASE-TX Port Status LED - Left (Link/Activity)

Amber	A 10BASE-T link is	—	If 10BASE-T operation is
	established.		desired, no action is required.
			If 10BASE-T operation is not
			desired, refer to Setting
			10BASE-T/100BASE-TX Port
			Modes of Operation on
			page 10 for information.

Flashing amber	Data activity is	—	If 10BASE-T operation is
	occurring on the		desired, no action is required.
	10BASE-T link; data		If 10BASE-T operation is not
	is being transmitted		desired, refer to Setting
	or received.		10BASE-T/100BASE-TX Port
			Modes of Operation on
			page 10 for information.

Green	A 100BASE-TX link	—	If 100BASE-TX operation is
	is established.		desired, no action is required.
			If 100BASE-TX operation is not
			desired, refer to Setting
			10BASE-T/100BASE-TX Port
			Modes of Operation on
			page 10 for information.

Flashing green	Data activity is	—	If 100BASE-TX operation is
	occurring on the		desired, no action is required.
	100BASE-TX link;		If 100BASE-TX operation is not
	data is being trans-		desired, refer to Setting
	mitted or received.		10BASE-T/100BASE-TX Port
			Modes of Operation on
			page 10 for information.

			(Continued on next page)

16	C2626M (2/07)

Image 16

Contents Ethernet Switch List of Illustrations ContentsList of Tables Important Safety Instructions Risk of Electric Shock Do not Open Regulatory Notices Radio and Television InterferenceProduct Overview DescriptionModels Rack mount chassisFront Panel of SX8205R Module Reset Button Restarts the unit Illustrates the front panel of the SX8205R moduleRear Panel Illustrates the rear panel of the SX8205R moduleInstallation Package ContentsAutonegotiation is enabled by default Flow control is disabled by defaultTable A. TX Mode Switch Settings Flow control default settingMounting Mounting the SX8205R Module Into a RackMounting the SX8205R Module Using the Wall Clip Connections 10BASE-T/100BASE-TX connectionsTroubleshooting Table C. Troubleshooting with Rear-Panel Indicators Desired, refer to SettingAmber 10BASE-T link is If 10BASE-T operation is Established 10 for informationSetting of the remote Not lit 10BASE-T orDo any of the following as 100BASE-TX link Cable Applicable Cannot beDuplex mode Duplex mode LinkIf half-duplex mode is Amber Port is set to If 10BASE-T full-duplexGreen Port is set to If 100BASE-TX full-duplex Flashing green Port is set to100BASE-TX half Replace cable if it isTable C. Troubleshooting with Rear-Panel Indicators Specifications Link/activity and speed, duplex/collision and speedAppendix. RJ-45 Connector Pinouts Illustrates RJ-45 MDI/MDI-X connector pinoutsProduct Warranty and Return Information ISO9001