Pelco SX8205R manual ISO9001

Page 24

®

Worldwide Headquarters

3500 Pelco Way

Clovis, California 93612 USA

USA & Canada

Tel: 800/289-9100

Fax: 800/289-9150

International

Tel: 1-559/292-1981

Fax: 1-559/348-1120

www.pelco.com

ISO9001

Australia Canada Finland France Germany Italy Macau The Netherlands Russia Singapore

South Africa Spain Sweden United Arab Emirates United Kingdom United States

Image 24

Contents Ethernet Switch Contents List of IllustrationsList of Tables Important Safety Instructions Risk of Electric Shock Do not Open Regulatory Notices Radio and Television InterferenceProduct Overview DescriptionModels Rack mount chassisFront Panel of SX8205R Module Reset Button Restarts the unit Illustrates the front panel of the SX8205R moduleRear Panel Illustrates the rear panel of the SX8205R moduleInstallation Package ContentsAutonegotiation is enabled by default Flow control is disabled by defaultTable A. TX Mode Switch Settings Flow control default settingMounting Mounting the SX8205R Module Into a RackMounting the SX8205R Module Using the Wall Clip Connections 10BASE-T/100BASE-TX connectionsTroubleshooting Table C. Troubleshooting with Rear-Panel Indicators Desired, refer to SettingAmber 10BASE-T link is If 10BASE-T operation is Established 10 for informationSetting of the remote Not lit 10BASE-T orDo any of the following as 100BASE-TX link Cable Applicable Cannot beDuplex mode Duplex mode LinkIf half-duplex mode is Amber Port is set to If 10BASE-T full-duplexGreen Port is set to If 100BASE-TX full-duplex Flashing green Port is set to100BASE-TX half Replace cable if it isTable C. Troubleshooting with Rear-Panel Indicators Specifications Link/activity and speed, duplex/collision and speedAppendix. RJ-45 Connector Pinouts Illustrates RJ-45 MDI/MDI-X connector pinoutsProduct Warranty and Return Information ISO9001