Network Technologies operation manual Connecting the CAT5 cable to the User Station

Connecting the CAT5 cable to the User Station

Make sure the CAT5 cable has been installed in accordance with the “Preparation for Installation” instructions on page 3. Connect the CAT5 cable to the “Cat 5” port on the User Station. (See Fig. 8.) When properly inserted the CAT5 cable end should snap into place.

WARNING: Never connect the PRIMUX-UZR User Station to an Ethernet card, Ethernet router, hub or switch ! or other Ethernet RJ45 connector of an Ethernet device. Damage to devices connected to the Ethernet may

result.

		RearViewofPRIMUX-UZRUserStation
				PS/2	R NETWORK	1275DannerDr Tel:330-562-7070
5VDC			USB		TECHNOLOGIESAurora,OH44202Fax:330-562-1999
				Devices	NTINCORPORATED	www.nti1.com
-2A			Devices	SUN
	+	RS232		Mouse Kybd Devices	Cat5	Monitor
+

RJ45male

CAT5connector CAT5cable

toMatrixSwitch

Figure 8- Connect CAT5 cable to User Station

NOTE: If an RJ45 wall outlet is being used, connect the other end of the extension cable to the RJ45 wall outlet.

Power Up for the first time

Note: The user devices, monitor, and CAT5 cable should already be connected before powering up the User Station.

1.Connect the AC adapter power connector to the 5VDC port on the User Station (see Fig. 9). Plug the AC adapter into a power outlet. The yellow LED on the RJ45 connector of the User Station should illuminate, indicating that a proper power connection has been made to it.

2.Re-connect the power cord to the CPU.

FYI: The Host Adapter is powered by the CPU.

3.Power up the monitor.

5VDC

-2A +

+

5VDC

AC

ADAPTER

RearViewofPRIMUX-UZRUserStation

		PS/2			R NETWORK		1275DannerDr Tel:330-562-7070
					TECHNOLOGIESAurora,OH44202Fax:330-562-1999
		Devices		NTI
	USB					NCORPORATED		www.nti1.com
	Devices		SUN
RS232		Mouse Kybd Devices			Cat5			Monitor

Barrel

PowerConnector

5VDC@ 2.0AOUTPUT

(Outside	(Inside
barrel)	barrel)

2.1mmx5.5mmFemale

YelowPowerLED GreenCommunicationLED

Figure 9- Connect the AC adapter to the User Station

4.With the User Station and Host Adapter connected via CAT5 cable, refer to "Using the PRIMUX CAT5 KVM Switch" on page 10.

FYI: The green LED on each RJ45 connector will illuminate anytime data traffic is passing between the Host Adapter and User Station, indicating proper CAT5 cable connection and communication. (See Fig. 9)

8