Sun Microsystems EC000066 manual Port

Page 33

CABLING

2.Route power, SAN, and LAN cables to the server through the CMA cable hangers (B below).

You need to route the following cables:

■one Ethernet LAN cable for the NETMGT port

■up to four Ethernet LAN cables for the LAN ports (NET0, NET1, NET2, and NET3).

■optical Fibre Channel cables for each SAN client (backup server).

A

B

3.Connect the power cords to the connectors on the power supplies, and secure them to the chassis using the clips provided (C below).

F

PORT 1

Tx

Rx

PORT 2

Tx

Rx

FIBRE

CHANNEL

PORT 1

Tx

Rx

PORT 2

Tx

Rx

FIBRE

CHANNEL

C

D

C

E

4.Route Ethernet LAN cables to the NETMGT port (D above) and the LAN ports, NET0, NET1, NET2, and NET3 (E), but do not connect them yet.

Wait to connect Ethernet cables until after LAN connectivity has been configured.

316196101 • A

Chapter 1 Installing VTL Value hardware 21

Image 33

Contents Virtual Tape Library Page Revision History Iv VTL Value Hardware Installation Guide Aug Contents Setting up the VTL Value Ilom service processor Removing VTL Value hardware Viii VTL Value Hardware Installation Guide Aug About this book Using this bookUnderstanding the conventions used in this book Taking advantage of this book’s hypertext featuresCommenting on this book Xii VTL Value Hardware Installation Guide Aug Installing the VTL Value appliance in an equipment rack Installing VTL Value hardwareObtaining required tools, personnel, and materials Remove both power supplies Remove the system controllerPreparing the slide-rail assemblies for installation Installing slide-rail assembliesAttaching the inner rails to the server chassis Positioning the outer/middle rail assembly in the rack VTL Value Hardware Installation Guide Aug 316196101 a Attaching the outer/middle rail assembly to the rack 316196101 a Sun Rack 1000 hardware uses metric screws Adjusting and securing middle/outer slide rails VTL Value Hardware Installation Guide Aug Mounting the appliance in the rack VTL Value Hardware Installation Guide Aug 316196101 a Installing VTL Value hardware Cabling Installing the cable management armAttaching the Outer Rail Extension VTL Value Hardware Installation Guide Aug 316196101 a Installing VTL Value hardware Installing data and power cables Routing and connecting cablesPort Starting the VTL appliance Powering up316196101 a Installing VTL Value hardware Powering down Understanding the Ilom Setting up the VTL Value Ilom service processorAttaching a laptop to the Ilom via the VTL private network Changing the IP address of the Ilom SPNext task Changing the IP address of the Ilom on Changing the IP address of the Ilom Resetting the default Ilom password Changing the Ilom passwordChecking the health of the internal storage systems Java starts, downloads files, and launches the Java console Accessing the Solaris desk top via the IlomRoot Running basic storage diagnostics Submirror 0 d31 No data errors are reported See the example below Changing the Solaris root passwordChanging the default Solaris root password Logging outLogging out of the operating system and Ilom 316196101 a VTL Value Hardware Installation Guide Aug Back and front panels VTL Value server Top hard disk drive or fan fault VTL private network addresses VTL Value Hardware Installation Guide Aug Connecting to Ilom via a serial port Log in to the CLI as root and enter the root password Ilom command reference Display information about PET alerts. You can NtpIPaddress VTL Value Hardware Installation Guide Aug Removing VTL Value hardware Shutting off system powerRemoving the cable management arm Removing the VTL appliance from a rack Preparing to remove the applianceRemoving the appliance from the rack VTL Value Hardware Installation Guide Aug