STARTING THE VTL APPLIANCE
2.Once standby power is on, start the VTL server. Use a stylus to press and release the recessed main power button on the server front panel (C below).
The VTL appliance ships with a
When the server is up and running on main power, the OK LED (D) stops blinking and stays lit.
CD
Next task: “Setting up the VTL Value ILOM service processor” on page 25.
▼Powering down
If you need to power off the appliance, you can proceed in any of three ways, depending on the circumstances.
1.Under normal circumstances, power off the server gracefully by using a stylus to press and release the power button on the front panel.
This is the normal way you shut down the VTL server. Pressing and releasing the power button causes the Advanced Configuration and Power Interface (ACPI) to stop the operating system in an orderly fashion before shutting main power off. It places the system in standby power mode. The OK LED on the front panel starts blinking.
2.In an emergency, power off the server immediately by using a stylus to press and hold the power button for four seconds.
This shuts the main power off and places the system in standby power mode. The OK LED on the front panel starts blinking.
3.Then, if you need to power off the appliance completely, so that neither the server nor the service processor draws power, unplug the AC power cords from the power supplies at the rear of the server.
The OK LED on the front panel is not lighted.
24 VTL Value Hardware Installation Guide • Aug 2007 | A • 316196101 |