Sun Microsystems EC000066 manual VTL Value Hardware Installation Guide Aug

Page 64

REMOVING THE VTL APPLIANCE FROM A RACK

3.Push the green plastic tabs on the middle slide rails to release the second stop and pull the server out about 36 inches from the rack.

4.If you do not have a mechanical lift, open the hard disk drive access cover and remove the disk drives in slots 2 to 46 and follow the important instructions in “If a mechanical lift is not available, make sure that at least four trained people are available to remove the server and/or reduce the weight of the server by removing components:” on page 51.

5.Slide the server completely out of the slide rails and place on a clean, stable surface.

Note – If you are removing the server in a data center with narrow aisles (under

44 inches or approximately 1.12 meters wide), you can order a narrow aisle removal kit from Sun Service.

52 VTL Value Hardware Installation Guide • Aug 2007

A • 316196101

Image 64
Contents Virtual Tape Library Page Revision History Iv VTL Value Hardware Installation Guide Aug Contents Setting up the VTL Value Ilom service processor Removing VTL Value hardware Viii VTL Value Hardware Installation Guide Aug Using this book About this bookTaking advantage of this book’s hypertext features Understanding the conventions used in this bookCommenting on this book Xii VTL Value Hardware Installation Guide Aug Installing VTL Value hardware Installing the VTL Value appliance in an equipment rackRemove both power supplies Remove the system controller Obtaining required tools, personnel, and materialsInstalling slide-rail assemblies Preparing the slide-rail assemblies for installationAttaching the inner rails to the server chassis Positioning the outer/middle rail assembly in the rack VTL Value Hardware Installation Guide Aug 316196101 a Attaching the outer/middle rail assembly to the rack 316196101 a Sun Rack 1000 hardware uses metric screws Adjusting and securing middle/outer slide rails VTL Value Hardware Installation Guide Aug Mounting the appliance in the rack VTL Value Hardware Installation Guide Aug 316196101 a Installing VTL Value hardware Installing the cable management arm CablingAttaching the Outer Rail Extension VTL Value Hardware Installation Guide Aug 316196101 a Installing VTL Value hardware Routing and connecting cables Installing data and power cablesPort Powering up Starting the VTL appliance316196101 a Installing VTL Value hardware Powering down Setting up the VTL Value Ilom service processor Understanding the IlomChanging the IP address of the Ilom SP Attaching a laptop to the Ilom via the VTL private networkNext task Changing the IP address of the Ilom on Changing the IP address of the Ilom Changing the Ilom password Resetting the default Ilom passwordChecking the health of the internal storage systems Accessing the Solaris desk top via the Ilom Java starts, downloads files, and launches the Java consoleRoot Running basic storage diagnostics Submirror 0 d31 Changing the Solaris root password No data errors are reported See the example belowLogging out Changing the default Solaris root passwordLogging out of the operating system and Ilom 316196101 a VTL Value Hardware Installation Guide Aug Back and front panels VTL Value server Top hard disk drive or fan fault VTL private network addresses VTL Value Hardware Installation Guide Aug Connecting to Ilom via a serial port Log in to the CLI as root and enter the root password Ilom command reference Display information about PET alerts. You can NtpIPaddress VTL Value Hardware Installation Guide Aug Shutting off system power Removing VTL Value hardwareRemoving the cable management arm Preparing to remove the appliance Removing the VTL appliance from a rackRemoving the appliance from the rack VTL Value Hardware Installation Guide Aug