Sun Microsystems 150 manual J502 J501 J504 IDE J503 IDE

Page 14

J502 J501

J504 IDE 1

J503 IDE 2

FIGURE 6 Riser Board, Side Two

13.Connect the power cable to the secondary hard drive (FIGURE 7).

14.Connect the power cable to the primary hard drive.

15.Connect the secondary hard drive to the cable connector labeled “Secondary HDD”.

The following diagram shows the cabling for the secondary hard drive.

Secondary HDD

IDE2 (J503)

Power cable

FIGURE 7 Secondary Hard Drive Cabling Configuration

Caution – Ensure that the cables will not be damaged when you replace the system cover.

10 Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation Guide • June 2002

Image 14

Contents Page Please Recycle Contents Cleaning a CD or DVD Handling and Storing CDs and DVDs Sun Blade 150 CD-ROM DVD-ROM, and Hard Drive Installation Required ToolsPowering Off the System Preparing to Replace ComponentsRemoving the System Cover Attaching the Antistatic Wrist Strap Removing the System CoverRemoving a Primary Hard Drive Attaching the Wrist Strap to the ChassisLift the hard drive tray from the hard drive Replacing a Primary Hard Drive Installing a Secondary Hard Drive Installing a Secondary Hard Drive J502 J501 J504 IDE J503 IDE Removing a CD-ROM or DVD-ROM Drive Replacing a CD-ROM or DVD-ROM Drive Removing and Replacing a CD-ROM or DVD-ROM DriveFinishing Component Replacement Replacing the System CoverPowering On the System Hard Drive MirroringInserting a CD or DVD Into the Drive Hard Drive Mirroring ConfigurationCD or DVD Handling and Use Handling and Storing CDs and DVDs Cleaning a CD or DVDEjecting a CD or DVD