Sun Microsystems 150 manual Ejecting a CD or DVD, Cleaning a CD or DVD

2.Place the CD (label side up) into the tray.

Ensure that the CD is properly set into the recessed area of the tray.

3.Push the tray to close it.

Ejecting a CD or DVD

You may need to unmount the CD before manually ejecting it.

There are three ways to eject a CD:

■Press the eject button on the front of the CD-ROM drive.

■Use software commands to eject the CD. Refer to the peripherals handbook that corresponds with your operating system.

■If the motorized eject mechanism does not operate, insert a thin, stiff wire (such as a paper clip) into the hole next to the eject button.

Cleaning a CD or DVD

If your CD-ROM drive cannot read a CD or DVD, the cause may be a dirty CD or DVD. Follow these guidelines to clean a CD or DVD:

■Use a soft, clean, lint-free, dry cloth.

■Clean the unlabeled side of the CD or DVD.

■Wipe the CD radially from the center to the outside.

■Use professional cleaning kits.

Caution – Do not use solvents such as benzine, paint thinner, antistatic aerosol

!spray, or abrasive cleaners to clean CDs.

Handling and Storing CDs and DVDs

Follow these guidelines when handling and storing CDs:

■Handle CDs only by their edges; avoid touching CD or DVD surfaces.

■Write only on the premarked label side of a CD or DVD. Use a soft felt-tip marker.

■Do not use CDs in high-dust environments.

■Keep CDs out of direct sunlight, extreme sources of heat or cold, and away from dust and moisture.

■Make sure CDs are at room temperature before using them.

■Store CDs in storage boxes so that they remain clean and free of dust.

16 Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation Guide • June 2002