Sun Microsystems 150 manual Removing a CD-ROM or DVD-ROM Drive

16.Detach the wrist strap, replace the system cover, and power on the system as described in “Finishing Component Replacement” on page 13.

Removing a CD-ROM or DVD-ROM Drive

1.Remove any CD or DVD media from the drive.

2.Power off the system, remove the system cover, and attach an antistatic wrist strap as described in “Preparing to Replace Components” on page 2.

Caution – Use proper ESD grounding techniques when handling components. Wear an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in antistatic bags before placing them on any surface.

3.Remove the following from the back of the CD-ROM or DVD-ROM drive (FIGURE 8):

■CD-ROM or DVD-ROM drive IDE cable connector

■Power cable connector

4.Using a No. 2 Phillips screwdriver, remove the two screws securing the CD-ROM or DVD-ROM drive to the chassis.

5.Place your fingers on the back of the CD-ROM or DVD-ROM drive. Push the CD- ROM or DVD-ROM drive toward the chassis front and remove it.

6.Place the CD-ROM or DVD-ROM drive on an antistatic mat.

Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation 11