Hard Drive Mirroring, Powering On the System

Powering On the System

1.Connect the system power cord to the system and to an AC power outlet.

2.Reconnect and turn on power to any peripherals (so that the system can recognize the peripherals when it is powered on).

3.Press the front panel power switch (FIGURE 10).

Power switch

FIGURE 10 System Power Switch

4.Verify the following:

■The front panel power indicator LED is on.

■The system fans are spinning.

If the system does not power on, see the “Troubleshooting” section in the Sun Blade 150 Getting Started Guide, 816-1161, or the Sun Blade 150 Service Manual, 816-4379.

Note – The Sun Blade 150 Getting Started Guide is translated into 10 languages. All 10 language versions are available on the CD-ROM that shipped with the Sun Blade 150 system.

Hard Drive Mirroring

This section describes the requirements and constraints of a hard drive mirroring solution that uses Solstice DiskSuiteTM software.

14 Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation Guide • June 2002