Sun Microsystems 150 manual Removing the System Cover

Page 7

2.Verify the following:

■The front panel power-indicator LED is off.

■The system fans are not spinning.

3.Turn off the power to the monitor and any peripheral equipment.

4.Disconnect cables to any peripheral equipment.

Caution – Pressing the power switch does not remove all power from the system; a trickle current remains in the power supply. To remove all power from the system, disconnect the power cord.

Removing the System Cover

1.Using a No. 2 Phillips screwdriver, remove the two screws securing the system cover to the chassis (FIGURE 2).

2.Slide the system cover toward the rear of the system until the cover tabs release.

3.Lift the system cover straight up and set the cover aside in a safe place.

Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation 3

Image 7

Contents Page Please Recycle Contents Cleaning a CD or DVD Handling and Storing CDs and DVDs Required Tools Sun Blade 150 CD-ROM DVD-ROM, and Hard Drive InstallationPreparing to Replace Components Powering Off the SystemRemoving the System Cover Removing the System Cover Attaching the Antistatic Wrist StrapAttaching the Wrist Strap to the Chassis Removing a Primary Hard DriveLift the hard drive tray from the hard drive Replacing a Primary Hard Drive Installing a Secondary Hard Drive Installing a Secondary Hard Drive J502 J501 J504 IDE J503 IDE Removing a CD-ROM or DVD-ROM Drive Removing and Replacing a CD-ROM or DVD-ROM Drive Replacing a CD-ROM or DVD-ROM DriveReplacing the System Cover Finishing Component ReplacementHard Drive Mirroring Powering On the SystemCD or DVD Handling and Use Hard Drive Mirroring ConfigurationInserting a CD or DVD Into the Drive Ejecting a CD or DVD Cleaning a CD or DVDHandling and Storing CDs and DVDs