Sun Microsystems 150 manual Finishing Component Replacement, Replacing the System Cover

Page 17

6.Detach the wrist strap, replace the system cover, and power on the system as described in “Finishing Component Replacement” on page 13.

Finishing Component Replacement

1.Remove the wrist strap from the system chassis and from your wrist.

2.Position the system cover onto the system chassis.

Caution – Ensure that the hard drive cables will not be damaged when you replace the system cover.

3.Slide the system cover toward the front of the system until the cover tabs lock (FIGURE 9).

4.Using a No. 2 Phillips screwdriver, replace the two screws securing the system cover to the chassis.

FIGURE 9 Replacing the System Cover

Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation 13

Image 17

Contents Page Please Recycle Contents Cleaning a CD or DVD Handling and Storing CDs and DVDs Required Tools Sun Blade 150 CD-ROM DVD-ROM, and Hard Drive InstallationPreparing to Replace Components Powering Off the SystemRemoving the System Cover Removing the System Cover Attaching the Antistatic Wrist StrapAttaching the Wrist Strap to the Chassis Removing a Primary Hard DriveLift the hard drive tray from the hard drive Replacing a Primary Hard Drive Installing a Secondary Hard Drive Installing a Secondary Hard Drive J502 J501 J504 IDE J503 IDE Removing a CD-ROM or DVD-ROM Drive Removing and Replacing a CD-ROM or DVD-ROM Drive Replacing a CD-ROM or DVD-ROM DriveReplacing the System Cover Finishing Component ReplacementHard Drive Mirroring Powering On the SystemInserting a CD or DVD Into the Drive Hard Drive Mirroring ConfigurationCD or DVD Handling and Use Handling and Storing CDs and DVDs Cleaning a CD or DVDEjecting a CD or DVD