Sun Microsystems LSI22320-SR To Prepare for Hardware Installation, Exit the operating environment

Page 14

To Prepare for Hardware Installation

1.Read and observe the safety information at the back of this book. See“Safety Agency Compliance Statements” on page 27.

2.Install the Solaris 8 2/04 (minimum required version) operating system on the host.

3.Install the Solaris 8 2/04 (minimum required version) recommended patch cluster on the host.

See the Sun StorEdge PCI/PCI-X Dual Ultra320 SCSI Host Adapter Release Notes for how to download and install the Solaris OS recommended patch cluster.

4.Install any required driver patches on the host.

See the release notes to find the applicable patches for the version of the Solaris OS that is installed on the host. Also see the release notes for how to download the driver and any required patches. If needed, see “To Access the Release Notes” on page viii.

Caution – If the driver and any required patches described in the release notes are

!not installed, you cannot use the host adapter.

5.Install the SunVTS software on the host.

The SunVTS software is shipped on the Supplemental Software CD-ROM along with the Solaris operating system CD-ROM. Read the user’s guide listed in “Before You Read This Book” on page v for how to install the SunVTS software.

6.Exit the operating environment.

Note – If your system supports the PCI hot-plug capability, refer to the service documentation that came with your system. Then continue with Step 8 below.

To inform any mounted users that the system will be going down, use the shutdown command. Otherwise, use the init 0 command. See the Man Pages for these commans or the Solaris AnswerBook documentation.

#shutdown

...

ok

7.Power off the system. Refer to the service documentation that came with your system.

4 Sun StorEdge PCI/PCI-X Dual Ultra320 SCSI Host Adapter Installation Guide • January 2007

Image 14
Contents Sun Microsystems, Inc Please Recycle Contents Specifications Preface Before You Read This BookUsing Unix Commands How This Book Is OrganizedTypographic Conventions Related DocumentationRight frame, under Use, click Documentation Accessing Sun DocumentationTo Access the Release Notes Sun Welcomes Your Comments Third-Party Web SitesContacting Sun Technical Support Page Installing, Connecting, and Testing the Host Adapter Features 1Sun StorEdge PCI/PCI-X Dual Ultra320 Scsi Host AdapterInstalling the Host Adapter Install the SunVTS software on the host To Prepare for Hardware InstallationInstall any required driver patches on the host Exit the operating environmentChoose a PCI-X or PCI slot for installing the host adapter Unpack the host adapter Remove the filler panel for the desired slot To Install the Host AdapterOpen the system Remove the wrist strap Close the systemConnecting the Host Adapter Testing the Host Adapter To Test the Installation Using the probe-scsi- all CommandTo Test the Installation With the SunVTS Software As superuser, open the SunVTS windowBooting the Host Adapter Page Ultra320 Scsi Configuration Target DevicesBus Length Table A-1Bus RestrictionsTermination Cabling and TerminationCabling Scsi Symbols LVD LVD/MSE HVDSpecifications Physical DimensionsPower Requirements Performance SpecificationsPCI Edge Connector Pin Definitions Trst Scsi Connector Pin Definitions Vhdci Connector Internal Scsi Connector+ATN P E N D I X C Declaration of Conformity Appendix C Declaration of Conformity Regulatory Compliance Statements FCC Class a NoticePlacement of a Sun Product Noise Level Safety Agency Compliance StatementsSymbols Modifications to EquipmentSelv Compliance Power Cord ConnectionBattery Warning System Unit CoverLaser Compliance Notice SymbolesRack System Warning CD and DVD DevicesConnexion du cordon d’alimentation Modification du matérielConformité Selv Mise en garde relative au système en rack Mise en garde relative aux batteries Couvercle de lunitéAvis de conformité des appareils laser Périphériques CD et DVDModifikationen des Geräts SymboleSicherheitsvorkehrungen Aufstellung von Sun-GerätenGehäuseabdeckung Anschluss des NetzkabelsWarnung bezüglich Batterien Warnungen bezüglich in Racks eingebauter SystemeMedidas de seguridad Hinweis zur Laser-KonformitätCD- und DVD-Geräte SímbolosNivel de ruido Modificaciones en el equipoColocación de un producto Sun Cumplimiento de la normativa para instalaciones SelvCubierta de la unidad del sistema Advertencia sobre las bateríasAdvertencia sobre el sistema en bastidor Danmark Suomi Dispositivos de CD y DVDNorge Sverige