Booting the Host Adapter
The Sun StorEdge
Note – A “warm” boot requires that the hard disk attached to the host adapter be powered on and available at the time the server is powered up. A “cold” boot, where both the server and hard disk are powered up at the same time, is not supported by the mpt driver.
After booting, you should install any required patches for the mpt driver. Refer to the Sun StorEdge
Note – The Sun StorEdge 3310 standalone SCSI array is presently limited to Ultra160 SCSI bus speeds only. Normally, the host adapter automatically lowers the transfer speed for attached storage devices that are not Ultra320 capable. However, for the Sun StorEdge 3310 standalone SCSI array, you must create an mpt.conf file to limit the Sun StorEdge
For instructions on creating the mpt.conf file, refer to the Sun StorEdge
Chapter 1 Installing, Connecting, and Testing the Host Adapter 11