Modem settings

NTI SERIMUX SERIES CONSOLE SWITCH

Copy Port Serial Settings

–Press [+] to select the current port as source in a port settings copy-paste process (except port 0).

–Then, press [*] to paste the port settings.

–Press [Y] to paste the selected port settings to the current port, [A] to paste to all ports, [S] to specify the destination port, or press any other key to cancel.

Display serial settings for different port number

Press [>] (greater than symbol) to display the next higher port serial settings, or press [<] (less than symbol) to display the previous port serial settings.

Press [Esc] or [Space] to return to the "Port settings" menu.

From the "Port settings" menu, press [6] to display the "Modem settings" menu.

Remote connections are possible if modems are used, usually by the users. The remote modem may call in to a local modem attached to a SERIMUX port. A minimum number of port modem settings can be adjusted in the SERIMUX to control the connection (try the default values first; refer to the manual(s) for the modems otherwise).

Figure 9- Modem settings menu

The administrator can initialize a modem attached to a SERIMUX port, or disconnect the modem. To control the modem connection from the "Modem settings" menu, the following functions are possible:

Function

Keystroke

Attach and initialize a modem	[1] - [A]
Disconnect a modem	[1] - [D]
Change the modem reset string	[2]
Change the initialization string	[3]
Change the hangup string	[4]
Enable hangup on "NO CARRIER"	[5]
Save the changes	[Enter]
Cancel the command	[Esc]
Reset to default values	[0]-[Y]

FYI: If an old modem is attached to a SERIMUX port, it may be necessary to enable the “Hang-up on “NO CARRIER” message” option, in order to hang-up and disconnect the attached modem when receiving this message. Press [5], then [Y] to enable or any other key to disable this option. Usually, this option should remain disabled.