Philips HTS5000W Switching on DVD system, Setting the TV, Switching to Eco Power standby mode

20

001-051-hts5x-01-Eng50

Getting Started

Step 1: Inserting batteries into the remote control

3

1

2

1 Open the battery compartment.

2 Insert two batteries type R06 or AA, following the indications (+-) inside the compartment.

3 Close the cover.

CAUTION!

– Remove batteries if they are exhausted or if the remote control is not to be used for a long time.

– Do not use old and new, or different types of batteries in combination.

– Batteries contain hazardous chemical substances, so they should be disposed of properly.

Using the remote control to operate the system

1 Aim the remote control directly at the remote sensor (iR) on the front panel.

2 Select the source you wish to control by pressing one of the source select buttons on the remote control (for example TV, TUNER).

3 Then select the desired function (for example É, S, T).

E n g l i s h

Step 2: Switching on the

DVD system

● Press the SOURCE control to select : DISC ™ FM ™ MW ™ TV ™ AUX ™ DI ™ DISC ....

OR

Press DISC, TV, TUNER or AUX/DI on the remote.

Switching to Eco Power standby mode

● Press STANDBY ON (B).

➜ The display screen will go blank.

Step 3: Setting the TV

After connecting the DVD system to your TV, you have to switch the TV to the correct programme number for the input socket (e.g.‘EXT’,‘0’,‘AV’) in order to view the playback from the DVD system.

1 Press SOURCE control until “DISC” appears on the display panel.

2 Turn on the TV and set it to the correct video-in channel. You should see the blue DVD background screen on the TV.

➜ Usually this channel is between the lowest and highest channels and may be called FRONT,A/V IN,VIDEO. See your TV manual for more details.

➜ Or, you may go to channel 1 on your TV, then press the Channel down button repeatedly until you see the Video In channel.

➜ Or, the TV remote control may have a button or switch that chooses between different video modes.

20 17/05/05, 1:18 PM 3139 115 23842