Paradyne Hotwiret 7986 installation instructions Snmp Traps Options

Page 15

Table 9. SNMP Traps Options

SNMP Traps

Possible Settings: Enable, Disable

Default Setting: Disable

Controls the generation of SNMP trap messages. The options for addresses and types of traps are located in this table.

Number of Trap Managers

Possible Settings: 1, 2, 3, 4, 5

Default Setting: 1

Sets the number of SNMP management systems that will receive SNMP traps.

NMS n IP Address

Possible Settings: 000.000.000.000 ± 223.255.255.255, Clear

Default Setting: 000.000.000.000

Specifies the Internet Protocol address used to identify each SNMP trap manager.

NMS n Destination

Possible Settings: DSL, COM

Default Setting: DSL

Provides the network destination path of each trap manager.

General Traps

Possible Settings: Disable, Warm, AuthFail, Both

Default Setting: Both

Determines which SNMP traps are sent to each trap manager.

Enterprise Specific Traps

Possible Settings: Enable, Disable

Default Setting: Disable

Determines if SNMP traps are generated for enterprise-specific events.

Link Traps

Possible Settings: Disable, Up, Down, Both

Default Setting: Both

Determines if SNMP traps are generated for link up and link down for one of the communication interfaces.

Link Trap Interfaces

Possible Settings: Network, G.703, All

Default Setting: All

Determines if the SNMP linkUp, SNMP linkDown, and interface-related enterpriseSpecific traps are generated for the network interface, G.703 interface, or both.

7986-A2-GZ40-00

March 1999

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Product Documentation on the World Wide Web Installation Overview+24 Vdc Power Supply Pinouts Connecting Power to the UnitConnecting to the Network Connecting to a DTEConnecting to a System Terminal Network Configuration Entering Identity InformationCO Site Choosing a Configuration Mode Configuring the Unit Using the Configuration MenusIf you select Then Select To Access To Configure Configuration Edit/DisplayNetwork Interface Options 703 Interface Options Communication Port Options 1 System OptionsCommunication Port Options 2 Telnet Session Options Communication Protocol Options Node IP Address Possible Settings 000.000.000.000 ±Node Subnet Mask Possible Settings 000.000.000.000 ± Default Network DestinationGeneral Snmp Management Options Community Name Possible Settings Ascii text field, PublicName 1 Access Name 2 AccessAccess Level Snmp NMS Security OptionsNMS IP Validation Snmp Traps Options Handling Precautions for STATIC-SENSITIVE Devices Configuring the Unit Using the Internal SwitchesSwitchpack S1 & S2 Switchpack LocationsSwitchpack S1 Definitions Switch # Allows you to OFF = Current Firmware Switchpack S2 Definitions Switch # Allows you toOFF = AutoRate Disabled All OFF =Important Safety Instructions EMI Warnings Warranty, Sales, Service, and Training InformationAsynchronous Terminal Interface Menu Document FeedbackCopyright E 1999 Paradyne Corporation
Top Page Image Contents