Paradyne Hotwiret 7986 installation instructions Configuring the Unit Using the Internal Switches

Page 16

Configuring the Unit Using the Internal Switches

If desired, use internal Switchpacks S1 and S2 to manually configure the unit.

!HANDLING PRECAUTIONS FOR STATIC-SENSITIVE DEVICES

		This product is designed to protect sensitive components from
		damage due to electrostatic discharge (ESD) during normal operation.
		When performing installation procedures, however, take proper static
		control precautions to prevent damage to equipment. If you are not
	496-15104	sure of the proper static control precautions, contact your nearest
	496-15104	sales or service representative.
		sales or service representative.

"Procedure

To configure the unit using internal Switchpacks S1 and S2:

1.Power down the unit and disconnect the power supply.

2.Remove the enclosure cover:

ÐInsert a small, flat screwdriver blade into the slots on one side of the cover and push to free the inner latches

ÐLift off the cover to expose the circuit board

3.Locate Switchpack S1.

4.Set Switch 1 on Switchpack S1 to ON to enable Switchpacks 1 and 2.

5.After you enable the switchpacks, set the switches to your desired configuration.

6.Replace and secure the cover.

7.Power up the board to reset and enable the new configuration.

16

March 1999

7986-A2-GZ40-00

Image 16

Contents Installation Overview Product Documentation on the World Wide WebConnecting Power to the Unit +24 Vdc Power Supply PinoutsConnecting to a DTE Connecting to the NetworkConnecting to a System Terminal Entering Identity Information Network ConfigurationCO Site Configuring the Unit Using the Configuration Menus Choosing a Configuration ModeIf you select Then Configuration Edit/Display Select To Access To ConfigureNetwork Interface Options 703 Interface Options System Options Communication Port Options 1Communication Port Options 2 Telnet Session Options Node IP Address Possible Settings 000.000.000.000 ± Node Subnet Mask Possible Settings 000.000.000.000 ±Default Network Destination Communication Protocol OptionsCommunity Name Possible Settings Ascii text field, Public Name 1 AccessName 2 Access General Snmp Management OptionsSnmp NMS Security Options Access LevelNMS IP Validation Snmp Traps Options Configuring the Unit Using the Internal Switches Handling Precautions for STATIC-SENSITIVE DevicesSwitchpack Locations Switchpack S1 & S2Switchpack S1 Definitions Switch # Allows you to Switchpack S2 Definitions Switch # Allows you to OFF = AutoRate DisabledAll OFF = OFF = Current FirmwareImportant Safety Instructions Warranty, Sales, Service, and Training Information EMI WarningsDocument Feedback Asynchronous Terminal Interface MenuCopyright E 1999 Paradyne Corporation