Paradyne Hotwiret 7986 Switchpack S2 Definitions Switch # Allows you to, OFF = AutoRate Disabled

Table 11 lists Switchpack S2 definitions.

Table 11. Switchpack S2 Definitions

Switch # . . .	Allows you to . . .	Default in Bold
1	Control whether the unit is an LTU or an NTU.
	OFF = NTU
	ON = LTU
2	Control enabling and disabling of the AutoRate capability. Only valid for
	units configured as LTU.
	OFF = AutoRate Disabled
	ON = AutoRate Enabled
3, 4, 5	Select one of eight preset DSL line rates (refer to Table 12).
	All OFF = 2064
6, 7	Not used
8	Emergency Use Only ± The 7986 has two banks of flash memory
	used to hold executable firmware. This switch allows you to switch
	between the two versions of firmware. This switch is independent from
	the position of Switch 1 on Switchpack S1 (switchpack enable/disable).
	OFF = Current Firmware
	ON = Previous Firmware

Use Table 12 to set the DSL Line Rate. Defaults are shown in bold.

Table 12. DSL Line Rate, Switches 3 ± 5 on Switchpack S2

Switch Position

5

4

3

DSL Line Rate

OFF	ON	ON	400 kbps
ON	OFF	OFF	528 kbps
ON	OFF	ON	784 kbps
ON	ON	OFF	1040 kbps
ON	ON	ON	1552 kbps

OFF

OFF OFF

2064 kbps

7986-A2-GZ40-00 March 1999 19