Paradyne Hotwiret 7986 EMI Warnings, Warranty, Sales, Service, and Training Information

Page 21

EMI Warnings

!WARNING:

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

The authority to operate this equipment is conditioned by the requirements that no modifications will be made to the equipment unless the changes or modifications are expressly approved by Paradyne Corporation.

!WARNING:

To Users of Digital Apparatus in Canada:

This Class A digital apparatus meets all requirements of the Canadian interference-causing equipment regulations.

Cet appareil numérique de la classe A respecte toutes les exigences du règlement sur le matérial brouilleur du Canada.

Warranty, Sales, Service, and Training Information

Contact your local sales representative, service representative, or distributor directly for any help needed. For additional information concerning warranty, sales, service, repair, installation, documentation, training, distributor locations, or Paradyne worldwide office locations, use one of the following methods:

￿Internet: Visit the Paradyne World Wide Web site at www.paradyne.com. (Be sure to register your warranty there. Select Service & Support Warranty Registration.)

￿Telephone: Call our automated system to receive current information by fax or to speak with a company representative.

ÐWithin the U.S.A., call 1-800-870-2221

ÐOutside the U.S.A., call 1-727-530-2340

7986-A2-GZ40-00

March 1999

21

Image 21
Contents Product Documentation on the World Wide Web Installation Overview+24 Vdc Power Supply Pinouts Connecting Power to the UnitConnecting to the Network Connecting to a DTEConnecting to a System Terminal Network Configuration Entering Identity InformationCO Site Choosing a Configuration Mode Configuring the Unit Using the Configuration MenusIf you select Then Select To Access To Configure Configuration Edit/DisplayNetwork Interface Options 703 Interface Options Communication Port Options 1 System OptionsCommunication Port Options 2 Telnet Session Options Node Subnet Mask Possible Settings 000.000.000.000 ± Node IP Address Possible Settings 000.000.000.000 ±Default Network Destination Communication Protocol OptionsName 1 Access Community Name Possible Settings Ascii text field, PublicName 2 Access General Snmp Management OptionsAccess Level Snmp NMS Security OptionsNMS IP Validation Snmp Traps Options Handling Precautions for STATIC-SENSITIVE Devices Configuring the Unit Using the Internal SwitchesSwitchpack S1 & S2 Switchpack LocationsSwitchpack S1 Definitions Switch # Allows you to OFF = AutoRate Disabled Switchpack S2 Definitions Switch # Allows you toAll OFF = OFF = Current FirmwareImportant Safety Instructions EMI Warnings Warranty, Sales, Service, and Training InformationAsynchronous Terminal Interface Menu Document FeedbackCopyright E 1999 Paradyne Corporation