Patton electronic 3202 manual Enable Command Menu

Page 71

Model 3202 Getting Started Guide	5 • Console and Telnet configuration

Enable Command Menu

The enable command menu lists commands for setting up the Model 3202. Move the cursor “ >>” to enable and press Enter. Type the supervisor password, which is root.

----------------------------------------------------------------------

Command: enable <CR>

Message: Please input the following information.

Supervisor password: ****

----------------------------------------------------------------------

In the enable sub menu, you can set up management features and upgrade software, back up the system conﬁg- uration and restore the system conﬁguration via utility tools.

To save your changes, you must write the new conﬁguration to NVRAM and reboot the Model 3202 to work with the new settings.

When you ﬁrst log in to the Model 3202 with the supervisor password, the main menu displays:

>> enable	Modify command privilege
setup	Configure system
status	Show running system status
show	View system configuration
write	Update flash configuration
reboot	Reset and boot system
ping	Packet internet groper command
admin	Setup management features
utility	TFTP upgrade utility
exit	Quit system

Table 17 explains the commands available in the main menu:

	Table 17. Enable Command Menu

Command	Description

enable	Change the conﬁguration and write changes to nonvolatile RAM (NVRAM).

setup	Initially conﬁgure the Model 3202.

status	View the status of the Model 3202

show	Show the system and conﬁguration

write	Update ﬂash conﬁguration. After you have completed all desired changes, make sure to
	write the new conﬁguration to NVRAM. Use the write command to save your changes
	and reboot the system or all of your changes will not take effect.

reboot	Reset and reboot system. After you have completed all desired changes, make sure to write
	the new conﬁguration to NVRAM. Use the reboot command to restart the system or all of
	your changes will not take effect.

ping	Check the connection to the Model 3202

admin	Set up advanced management features

utility	Upgrade software and backup/restore the current conﬁguration

exit	Log out of the system

Enable Command Menu

71

Image 71

Contents RocketLink Model Mailsupport@patton.com Summary Table of Contents Table of Contents Web configuration Console and Telnet configuration Contacting Patton for assistance Port pin-outs List of Figures Model 3202 Getting Started Guide List of Tables Structure About this guideAudience Impaired functioning PrecautionsModel 3202 ﬁrst Safety when working with electricityPreventing Electrostatic Discharge Damage Tected by a circuit breakerGeneral observations Clean the case with a soft slightly moist anti-static clothGeneral conventions Typographical conventions used in this documentGeneral information Chapter contentsModel Model 3202 overviewLAN 1-4100M Model 3202 front panelLED descriptions WAN 1-4 LinkDC 9V 2A Model 3202 rear panelPort descriptions Ground terminal Reset buttonApplications overview Typical application IntroductionDistance Chart Model 3202/4W 4 Wire/2 Pair Distance chartsDistance Chart 3200 Series Per Wire Pair Distance Chart Model 3202/8W 8 Wire/4 Pair Hardware installation Planning the installation IP related information Network diagramAC Power Mains Unpacking the Model Installing the ModelConnecting cables Location and mounting requirementsGrounding stud Grounding the Model 3202 and connecting powerTelnet conﬁguration requirements Conﬁguring the ModelWeb conﬁguration requirements Console conﬁguration requirementsWeb conﬁguration Web configuration System Login Setting Up the WMITCP/IP setup Basic Conﬁguration Options Operation mode and Mgmt portDhcp server Subnet Mask Host Name SohoLAN IP Address Subnet Mask Gateway DNS Server 1 DNS Server 2 Review and save basic setup changesAnnex Type Advanced Conﬁguration OptionsLine Type SNR Margin Wire modelTcpam Type Main RateVlan VID 1Q Tag-Based Vlan 802.1Q Tag-Based Vlan802.1Q Vlan Web configuration Port-Based Vlan Port-Based VlanTpid Tag Protocol Identiﬁer Enter 33024 for IEEE802.1Q Port-Based QinQQuality of Service QoS QoS Port Based Priority Port Based PriorityQoS Vlan Tag Priority Vlan Tag PriorityDefault IP Dscp Priority Service by WRRThroughput Normal High Reliability Delay NormalStays the same link layer and routing protocol keep alive ClassQoS IP Dscp Priority Rate Control Rate ControlMgmt Status Status OptionsLine Status LAN Status Administration OptionsSecurity Administration Remote Management Hosts User ProﬁlesSnmp Administration Snmp AdministrationSnmp community pool conﬁguration Community PoolSystem Information Utility OptionsTrap Host Pool Conﬁguration Tool Conﬁguration ToolLogout UpgradeRestart RestartDhcp Server Dhcp Fixed Host DNS Proxy Host Name Console and Telnet conﬁgurationConsole and Telnet configuration Log in to the console interface Log in using TelnetInterface commands Ctrl + C Quit conﬁguring the item Ctrl +Q Access helpConsole/Telnet Menu Window structureMenu tree for authorized users Main Menu TreeMain screen for authorized users Menu tree for unauthorized usersEnable Command Menu Setup Command Menu Maximum Main Rate ModeLink IP Address Subnet Mask ClearVlan Mode Setup Command Menu Pvid QoS QoS ModeQueue Schedule Queue WeightQoS Mode Weight Value Vlan Tag Priority QoS Port-Based Priority QoSVlan Tag Index 0 1 2 3 4 5 6 Queue Index IP Dscp Priority QoSPort Snifﬁng ListRate PortMgmt Dhcp Fixed Host Dhcp ServerHost Name Factory DefaultDNS Proxy Shdsl Status Command MenuShdsl Status Interface StatusConﬁg Show Command MenuWrite Command SystemPing Command Reboot CommandModify/Add User Administration Command MenuUser Proﬁle Legal IP Address Pool SecurityTelnet TCP Port Community SnmpDenied Trap hostReadOnly ReadWriteSupervisor ID Supervisor Password and IDSupervisor Password Restore system conﬁguration Utility Command MenuUpgrade main software Backup system conﬁgurationExit Command Contacting Patton for assistance Contact information Warranty coverageRMA numbers Out-of-warranty serviceReturns for credit Return for credit policyAppendix a Compliance information Authorized European Representative ComplianceRadio and TV interference FCC Part CE Declaration of ConformityAppendix B Speciﬁcations Shdsl Speciﬁcations Shdsl ConnectorEthernet Connector Management ConnectorWeight Front Panel IndicatorsPower Supply DimensionsAppendix C Port pin-outs EIA-561 RJ-45 8-pin port Console portEthernet