Patton electronic 1092ARC Main Menu Option 4 Setup Software Configuration, DTE Rate, Data Format

MAIN MENU Option 4: Setup Software Configuration

Select Option 4 to edit the software configuration of the Model 1092ARC. To save changes after editing the software configuration, select MAIN MENU Option 5, then select “Use Software Switches” and then select MAIN MENU Option 8 to save.

********************************************************

* SOFTWARE CONFIGURATION MENU - Esc to MAIN MENU	*
*	*
* 1. DTE Rate	*
* 2. Data Format (Async/Sync)	*
* 3. Clock Mode	*
* 4. DSR during Local Line Loop	*
* 5. Response to Remote Digital Loop	*
* 6. DTE controlled Local Line Loop	*
* 7. DTE controlled Digital Loop	*
* 8. 4-Wire/2-Wire selection	*
*	*

********************************************************

1. DTE Rate

Select Option 1 in the SOFTWARE CONFIGURATION menu to

select the sync. DTE Rate of the Model 1092ARC. The selections are shown below.

2. Data Format

Select Option 2 in the SOFTWARE CONFIGURATION Menu to select the sync data format (See below).

3. Clock Mode

Select Option 3 in the SOFTWARE CONFIGURATION Menu to select the sync clock mode (See below).

Set this option as follows:

Master Clock - Internal: Select Item 1 to use the Model 1092ARC internal reference clock as the timing source.

Master Clock - External: Select Item 2 to use the DTE supplied transmit clock.

Slaved to Receive Clock: Select Item 3 to have the Model 1092ARC Series derives a transmit clock from the incoming data stream.

Important: One 1092ARC must be a Master Clock (either internal or external) and the other must be Slaved to the Receive Clock.

15 16