Patton electronic 4630 Series manual Isdn BRI

Page 51

SmartNode 4630 Getting Started Guide	C • Cabling

ISDN BRI

The ISDN ports are connected to ISDN terminals (Phones PBXs) or an ISDN NT using cables terminated with RJ-45 connectors. Use straight-though cables to connect to the S/T port of your NT or phones/PBX.

The interconnecting cables shall be acceptable for external use and shall be rated for the proper application with respect to volt- age, current, anticipated temperature, ﬂammability, and

CAUTION mechanical serviceability.

When this device is used in North America, it shall be connected to a Network Termination Device and not connected directly to an outside POTS line.

CAUTION

RJ-45, male		RJ-45, male
3			3

4			4

5			5

6			6

		Note: Other pins are not used.

Figure 11. Connecting an ISDN device

ISDN BRI

51

Image 51

Contents SmartNode 4630 Series Mailsupport@patton.com Summary Table of Contents Table of Contents Contacting Patton for assistance Cabling List of Figures List of Tables About this guide AudienceStructure Safety when working with electricity PrecautionsTypographical conventions used in this document General observationsGeneral conventions Node General information Chapter contentsSmartNode SmartNode 4630 overviewBRI 0/0 SmartNode 4630 rear panelBRI 0/3 60 Hz ResetBRI 0/1 BRI 0/2Power SmartNode 4630 front panelRun Ethernet 100M VoIP LinkBRI Link/Sig Ethernet LinkApplications overview Application-Edge intelligence of enterprise communication IntroductionHow it works Application-Multi-service Isdn Internet telephony IADApplications overview SmartNode installation Network information Planning the installationNetwork Diagram Site logInstalling the gateway router Connecting the 10/100Base-T Ethernet LAN and WAN cables Connecting the power supply Initial conﬁguration Connecting the SmartNode to your laptop PC Connecting the SmartNode to your laptop PCChanging the WAN IP address Factory-default IP settingsLogin Conﬁguring the desired IP addressConnecting the SmartNode to the network Connecting the SmartNode to the networkLoading the conﬁguration optional Load a new application image SmartWare via Tftp BootloaderStart Bootloader Start-up with factory conﬁgurationOptional RedBoot load -r -v -h host -b RedBoot load -r -v -m Load a new application image SmartWare via the serial linkXmodem ymodem -b Additional information Contacting Patton for assistance Warranty coverage Contact informationPatton support headquarters in the USA RMA numbers Out-of-warranty serviceAppendix a Compliance information CE Declaration of Conformity SafetyCompliance Radio and TV InterferenceIsdn compliance Appendix B Speciﬁcations Voice processing signalling dependent Voice connectivityData connectivity Voice signalling Fax and modem supportVoice routing-session router Physical IP servicesManagement SystemSmartNode Model SysObjectID Identiﬁcation of the SmartNode devices via SnmpAppendix C Cabling Console Connecting a serial terminalEthernet Typical Ethernet straight-through cable diagramIsdn BRI Appendix D Port pin-outs Isdn BRI 0/0 NT/Net or TE/User port Console portIsdn BRI 0/1 . /3 TE/Usr or NT/Net Appendix E SmartNode 4630 factory conﬁguration Introduction Appendix F End user license agreement End User License Agreement Other licenses Termination