Patton electronic 4630 Series manual Optional RedBoot load -r -v -h host -b

SmartNode 4630 Getting Started Guide4 • Initial configuration

Step	Command	Purpose
3	RedBoot> ping -htftp-server_ip_address	Tests the connectivity to the TFTP server.
optional
4	RedBoot> load -r -v -h host -b	Downloads an application image into the vola-
	base_address file_name	tile memory (RAM) from where the SmartNode
		could directly execute it.
		host: IP address of the TFTP server
		base_address: memory location where to store
		the application image. Use the default address
		0x1800100
		file_name: path and name of the file on the
		TFTP server. Note: use the image file that con-
		tains the whole application, not the image
		parts.
5	RedBoot> fis delete -n 1	Deletes the first application image.
		Reply with ‘y’ to the confirmation request.
6	RedBoot> fis create	Stores the downloaded application image to
		the permanent memory (flash:).
		Reply with ‘y’ to the confirmation request.
7	RedBoot> fis list -l	Checks whether the image has been success-
		fully stored, whether it is the desired Release
		and Build, and whether it is valid.
8	RedBoot> go	Starts the application image that was down-
		loaded into the volatile memory (RAM).

Note With the Bootloader, only the Ethernet interface 0/0 is available. The Boot- loader applies the IP address, subnet mask, and default gateway that were last configured by the Bootloader itself or by another application (e.g. Smart- Ware). If an application configured the Ethernet interface 0/0 to use DHCP, the Bootloader will also use DHCP to learn the interface configuration. It can receive and apply the IP address, subnet mask, default gateway, and default (TFTP) server (transmitted as basic DHCP information ‘Next server IP address’).

Note This procedure does not download the respective CLI description file.

Download it after starting up SmartWare with the following command:

copy tftp://<tftp_server_address>/<server path>/b1 flash:

Example: Downloading and storing a new application image (SmartWare)

RedBoot> ip -l 172.16.40.98/19 RedBoot> ip -g 172.16.32.1 RedBoot> ping -h 172.16.32.100

Network PING - from 172.16.40.98 to 172.16.32.100

..........PING - received 10 of 10 expected

RedBoot> load -r -v -h 172.16.32.100 -b 0x1800100 /Sn4xxx/image.bin Using default protocol (TFTP)

-

Bootloader 34