Patton electronic 4630 Series manual VoIP Link, BRI Link/Sig, Ethernet Link, Ethernet 100M

Page 18

SmartNode 4630 Getting Started Guide1 • General information

	Table 3. SmartNode 4630 LED deﬁnitions (Continued)

LED	Description

VoIP Link	• On indicates the gateway is registered to an H.323 gatekeeper/SIP server, or,
	in the case of direct routing, has at least one active VoIP connection.
	• Off indicates the unit is not conﬁgured or registered, or has no active direct-
	routed VoIP connection.
	• Flashing green indicates that the unit is attempting to register or has failed
	to register.

BRI Link/Sig	On when L1 and L2 are active. Flash to follow signaling activity on D-Channel.

BRI B1/B2	Off indicates no active calls. Blinking when one or two B-channels are connected.

Ethernet Link	• On when the Ethernet connection on the corresponding port has a
	link indication.
	• Flashes when data is received or transmitted at the corresponding Ethernet port.

Ethernet 100M	• On when the Ethernet is connected to a 100Mb network
	• Off when the Ethernet is connected to a 10Mb network.

SmartNode 4630 overview

18

Image 18

Contents SmartNode 4630 Series Mailsupport@patton.com Summary Table of Contents Table of Contents Contacting Patton for assistance Cabling List of Figures List of Tables About this guide AudienceStructure Precautions Safety when working with electricityTypographical conventions used in this document General observationsGeneral conventions Node Chapter contents General informationSmartNode 4630 overview SmartNodeSmartNode 4630 rear panel BRI 0/0BRI 0/2 60 Hz ResetBRI 0/1 BRI 0/3Power SmartNode 4630 front panelRun Ethernet Link VoIP LinkBRI Link/Sig Ethernet 100MApplications overview Introduction Application-Edge intelligence of enterprise communicationApplication-Multi-service Isdn Internet telephony IAD How it worksApplications overview SmartNode installation Site log Planning the installationNetwork Diagram Network informationInstalling the gateway router Connecting the 10/100Base-T Ethernet LAN and WAN cables Connecting the power supply Initial conﬁguration Connecting the SmartNode to your laptop PC Connecting the SmartNode to your laptop PCConﬁguring the desired IP address Factory-default IP settingsLogin Changing the WAN IP addressConnecting the SmartNode to the network Connecting the SmartNode to the networkLoading the conﬁguration optional Start-up with factory conﬁguration BootloaderStart Bootloader Load a new application image SmartWare via TftpOptional RedBoot load -r -v -h host -b RedBoot load -r -v -m Load a new application image SmartWare via the serial linkXmodem ymodem -b Additional information Contacting Patton for assistance Warranty coverage Contact informationPatton support headquarters in the USA Out-of-warranty service RMA numbersAppendix a Compliance information Radio and TV Interference SafetyCompliance CE Declaration of ConformityIsdn compliance Appendix B Speciﬁcations Voice processing signalling dependent Voice connectivityData connectivity Voice signalling Fax and modem supportVoice routing-session router System IP servicesManagement PhysicalIdentiﬁcation of the SmartNode devices via Snmp SmartNode Model SysObjectIDAppendix C Cabling Connecting a serial terminal ConsoleTypical Ethernet straight-through cable diagram EthernetIsdn BRI Appendix D Port pin-outs Console port Isdn BRI 0/0 NT/Net or TE/User portIsdn BRI 0/1 . /3 TE/Usr or NT/Net Appendix E SmartNode 4630 factory conﬁguration Introduction Appendix F End user license agreement End User License Agreement Termination Other licenses