Patton electronic 5200 Installing cables, Connecting the 10/100Base-T Ethernet LAN and WAN cables

Page 23

SmartNode 5200 Getting Started Guide

3 • SmartNode installation

 

 

Installing cables

Do not work on the system or connect or disconnect cables during periods of lightning activity.

Connect the cables in the following order:

1.Connect the 10/100Base-T Ethernet LAN and WAN (see section “Connecting the 10/100Base-T Ether- net LAN and WAN cables” on page 23)

2.Connect the power supply (see section “Connecting the power supply” on page 23)

Connecting the 10/100Base-T Ethernet LAN and WAN cables

The SmartNode 5200 has automatic MDX (auto-crossover) detection and configuration on all Ethernet ports. Any of the ports can be connected to a host or hub/switch with a straight-through wired cable.

1.Connect port ETH 0/0 to the subscriber port of the broadband access modem (DSL, cable, WLL).

2.Connect Ethernet ports 1 to 4 to your LAN devices (PC, printer, switches, etc.)

For details on the Ethernet port pinout and cables, refer to Appendix C, “Cabling” on page 39 and Appendix D, “Port pin-outs”on page 41.

Connecting the power supply

Do the following to connect the power supply to the Model 5200:

Note Do not connect the power cord to the AC power outlet at this time.

1.Insert the barrel-type connector end of the AC power supply into the 5V DC, 1.0A port (see figure 2 on page 16).

The external router power supply automatically adjusts to accept an input voltage from 100 to 240 VAC (50/60 Hz).

Verify that the proper voltage is present before plugging the power cord into the receptacle. Failure to do so could result in equipment damage.

2.Verify that the AC power cord included with your router is compatible with local standards. If it is not, refer to “Contacting Patton for assistance” on page 31 to find out how to replace it with a compatible power cord.

3.Connect the male end of the AC power supply power cord to an appropriate AC power outlet.

Installing the gateway router

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents SmartNode Mailsupport@patton.com Summary Table of Contents Table of Contents Cabling End user license agreement List of Figures List of Tables Structure About this guideAudience Impaired functioning PrecautionsSafety when working with electricity General observations General conventions Typographical conventions used in this documentGeneral information Chapter contentsSmartNode SmartNode 5200 overviewWAN ETH 0/0 SmartNode 5200 rear panelLED SmartNode 5200 front panelApplications overview Typical application IntroductionSmartNode installation Network information Planning the installationNetwork Diagram Site logInstalling the gateway router Connecting the 10/100Base-T Ethernet LAN and WAN cables Installing cablesRouter front panel LEDs Initial configuration Connecting the SmartNode to your laptop PC Connecting the SmartNode to your laptop PCChanging the WAN IP address Configuring the desired IP addressFactory-default IP settings LoginLAN Connecting the SmartNode to the networkLoading the configuration optional Additional information Contacting Patton for assistance Patton support headquarters in the USA Warranty coverageContact information RMA numbers Out-of-warranty serviceAppendix a Compliance information Authorized European Representative Low-Voltage Directive SafetyCompliance CE Declaration of ConformityAppendix B Specifications Management Voice signallingIP services Data connectivityOperating environment DimensionsWeight and power dissipation Operating temperatureAppendix C Cabling Ethernet Typical Ethernet straight-through cable diagramAppendix D Port pin-outs Pin Signal Appendix E SmartNode 5200 factory configuration SmartNode 5200 factory configuration Interface eth1 Authentication Outbound Authenticate Bind interface eth0 router no shutdown Appendix F End user license agreement End User License Agreement Other licenses Termination
Top Page Image Contents