Patton electronic 5200 Configuring the desired IP address, Factory-default IP settings, Login

Page 27

SmartNode 5200 Getting Started Guide

4 • Initial configuration

 

 

Configuring the desired IP address

Factory-default IP settings

The factory default configuration for the Ethernet interface IP addresses and network masks are listed in table 5. Both Ethernet interfaces are activated upon power-up. LAN interface ETH 0/1 (LAN) provides a default DHCP server, the WAN interface uses DHCP client to automatically assign the IP address and network mask.

Table 5. Factory default IP address and network mask configuration

 

IP Address

Network Mask

 

 

 

WAN interface Ethernet 0 (ETH 0/0)

DHCP

DHCP

LAN interface Ethernet 1 (ETH 0/1)

192.168.1.1

255.255.255.0

 

 

 

DHCP address range

192.168.1.10–192.168.1.19

255.255.255.0

 

 

 

If these addresses match with those of your network, go to section “Connecting the SmartNode to the net- work” on page 28. Otherwise, refer to the following sections to change the addresses and network masks.

Login

To access the SmartNode, start the Telnet application. Type the default IP address for the router into the address field: 192.168.1.1. Accessing your SmartNode via a Telnet session displays the login screen. Type the factory default login: administrator and leave the password empty. Press the Enter key after the password prompt.

login:administrator

password: <Enter> 192.168.1.1>

After you have successfully logged in you are in the operator execution mode, indicated by > as command line prompt. With the commands enable and configure you enter the configuration mode.

192.168.1.1>enable 192.168.1.1#configure 192.168.1.1(cfg)#

Changing the WAN IP address

Select the context IP mode to configure an IP interface.

192.168.1.1(cfg)#context ip router 192.168.1.1(ctx-ip)[router]#

Configuring the desired IP address

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents SmartNode Mailsupport@patton.com Summary Table of Contents Table of Contents Cabling End user license agreement List of Figures List of Tables About this guide AudienceStructure Impaired functioning PrecautionsSafety when working with electricity General observations General conventions Typographical conventions used in this documentGeneral information Chapter contentsSmartNode SmartNode 5200 overviewWAN ETH 0/0 SmartNode 5200 rear panelLED SmartNode 5200 front panelApplications overview Typical application IntroductionSmartNode installation Network information Planning the installationNetwork Diagram Site logInstalling the gateway router Connecting the 10/100Base-T Ethernet LAN and WAN cables Installing cablesRouter front panel LEDs Initial configuration Connecting the SmartNode to your laptop PC Connecting the SmartNode to your laptop PCChanging the WAN IP address Configuring the desired IP addressFactory-default IP settings LoginLAN Connecting the SmartNode to the networkLoading the configuration optional Additional information Contacting Patton for assistance Warranty coverage Contact informationPatton support headquarters in the USA RMA numbers Out-of-warranty serviceAppendix a Compliance information Authorized European Representative Low-Voltage Directive SafetyCompliance CE Declaration of ConformityAppendix B Specifications Management Voice signallingIP services Data connectivityOperating environment DimensionsWeight and power dissipation Operating temperatureAppendix C Cabling Ethernet Typical Ethernet straight-through cable diagramAppendix D Port pin-outs Pin Signal Appendix E SmartNode 5200 factory configuration SmartNode 5200 factory configuration Interface eth1 Authentication Outbound Authenticate Bind interface eth0 router no shutdown Appendix F End user license agreement End User License Agreement Other licenses Termination
Top Page Image Contents