Patton electronic 5200 manual Typical Ethernet straight-through cable diagram

Page 40

SmartNode 5200 Getting Started Guide	C • Cabling

Introduction

This section provides information on the cables used to connect the SmartNode and the interface cards to the existing network infrastructure and to third party products.

Ethernet

Ethernet devices (10Base-T/100Base-T) are connected to the SmartNode over a cable with RJ-45 plugs. All Ethernet ports on the SN5200 & SN4562 are Auto-MDX and use any straight or crossover cable to connect to hubs, switches, PCs or other devices.

	Hub
	Straight-through cable
RJ-45, male	RJ-45, male
1	1
2	2
3	3
6	6
	Note: Other pins are not used.

Figure 8. Typical Ethernet straight-through cable diagram

Introduction

40

Image 40

Contents SmartNode Mailsupport@patton.com Summary Table of Contents Table of Contents Cabling End user license agreement List of Figures List of Tables Audience About this guideStructure Precautions Impaired functioningSafety when working with electricity General observations Typographical conventions used in this document General conventionsChapter contents General informationSmartNode 5200 overview SmartNodeSmartNode 5200 rear panel WAN ETH 0/0SmartNode 5200 front panel LEDApplications overview Introduction Typical applicationSmartNode installation Planning the installation Network DiagramSite log Network informationInstalling the gateway router Installing cables Connecting the 10/100Base-T Ethernet LAN and WAN cablesRouter front panel LEDs Initial configuration Connecting the SmartNode to your laptop PC Connecting the SmartNode to your laptop PCConfiguring the desired IP address Factory-default IP settingsLogin Changing the WAN IP addressConnecting the SmartNode to the network LANLoading the configuration optional Additional information Contacting Patton for assistance Contact information Warranty coveragePatton support headquarters in the USA Out-of-warranty service RMA numbersAppendix a Compliance information Low-Voltage Directive Safety ComplianceCE Declaration of Conformity Authorized European RepresentativeAppendix B Specifications Voice signalling IP servicesData connectivity ManagementDimensions Weight and power dissipationOperating temperature Operating environmentAppendix C Cabling Typical Ethernet straight-through cable diagram EthernetAppendix D Port pin-outs Pin Signal Appendix E SmartNode 5200 factory configuration SmartNode 5200 factory configuration Interface eth1 Authentication Outbound Authenticate Bind interface eth0 router no shutdown Appendix F End user license agreement End User License Agreement Termination Other licenses