Patton electronic manual SmartNode 5200 front panel, Led

Page 17

SmartNode 5200 Getting Started Guide

1 • General information

Figure 3. SmartNode 5200 front panel

SmartNode 5200 front panel

Figure 3 shows SmartNode 5200 LEDs, the LED definitions are listed in table 3.

	Table 3. SmartNode 5200 LED definitions

LED	Description

Note	If an error occurs, all LEDs will flash once per second.
Power	When lit, indicates power is applied and the unit is in normal operation. Off indi-
	cates no power applied. Flashes once per second during boot (startup).

VoIP Link	• On indicates the gateway is registered to an H.323 gatekeeper/SIP server, or,
	in the case of direct routing, has at least one active VoIP connection.
	• Off indicates the unit is not configured or registered, or has no active direct-
	routed VoIP connection.
	• Flashing green indicates that the unit is attempting to register or has failed
	to register.
Ethernet	• On when the Ethernet connection on the corresponding port has a
(LAN 1–4 and WAN)	link indication.
	• Flashes when data is received or transmitted at the corresponding Ethernet port.

SmartNode 5200 overview

17

Image 17

Contents SmartNode Mailsupport@patton.com Summary Table of Contents Table of Contents Cabling End user license agreement List of Figures List of Tables Structure About this guideAudience Impaired functioning PrecautionsSafety when working with electricity General observations General conventions Typographical conventions used in this documentGeneral information Chapter contentsSmartNode SmartNode 5200 overviewWAN ETH 0/0 SmartNode 5200 rear panelLED SmartNode 5200 front panelApplications overview Typical application IntroductionSmartNode installation Network Diagram Planning the installationSite log Network informationInstalling the gateway router Connecting the 10/100Base-T Ethernet LAN and WAN cables Installing cablesRouter front panel LEDs Initial configuration Connecting the SmartNode to your laptop PC Connecting the SmartNode to your laptop PCFactory-default IP settings Configuring the desired IP addressLogin Changing the WAN IP addressLAN Connecting the SmartNode to the networkLoading the configuration optional Additional information Contacting Patton for assistance Patton support headquarters in the USA Warranty coverageContact information RMA numbers Out-of-warranty serviceAppendix a Compliance information Compliance Low-Voltage Directive SafetyCE Declaration of Conformity Authorized European RepresentativeAppendix B Specifications IP services Voice signallingData connectivity ManagementWeight and power dissipation DimensionsOperating temperature Operating environmentAppendix C Cabling Ethernet Typical Ethernet straight-through cable diagramAppendix D Port pin-outs Pin Signal Appendix E SmartNode 5200 factory configuration SmartNode 5200 factory configuration Interface eth1 Authentication Outbound Authenticate Bind interface eth0 router no shutdown Appendix F End user license agreement End User License Agreement Other licenses Termination