Patton electronic 5200 manual Termination, Other licenses

Page 50

SmartNode 5200 Getting Started Guide

F • End user license agreement

 

 

If the Program(s) are acquired by or on behalf of a unit or agency of the United States Government, the Gov- ernment agrees that such Program(s) are commercial computer software or computer software documentation and that, absent a written agreement to the contrary, the Government’s rights with respect to such Program(s) are limited by the terms of this Agreement, pursuant to Federal Acquisition Regulations 12.212(a) and/or DEARS 227.7202-1(a) and/or sub-paragraphs (a) through (d) of the “Commercial Computer Software - Restricted Rights” clause at 48 C.F.R. 52.227-19 of the Federal Acquisition Regulations as applicable.

6. Termination

A)The End User may terminate this agreement by returning the Designated Equipment and destroying all copies of the licensed Program(s).

B)Patton Electronics Company may terminate this Agreement should End User violate any of the provi- sions of section “4. Grant of License” on page 49.

C)Upon termination for A or B above or the end of the Term, End User is required to destroy all copies of the licensed Program(s)

7. Other licenses

The Program may be subject to licenses extended by third parties. Accordingly, Patton Electronics Company licenses the Programs subject to the terms and conditions dictated by third parties. Third party software identi- fied to the Programs includes:

•A routing license is included at no charge.

•MGCP and VPN capabilities will require the purchase of an additional license.

•The LGPL (Lesser General Public License) open source license distributed to you pursuant to the LGPL license terms (http://www.gnu.org/licenses/lgpl.html).

•RedBoot (Red Hat Embedded Debug and Bootstrap) embedded system debug/bootstrap environment from Red Hat distributed to you pursuant to the eCos license terms (http://ecos.sourceware.org/license- overview.html) and GNU General Public License (GPL) terms (http://www.gnu.org/copyleft/gpl.html). Source code is available upon request.

End User License Agreement

50

Page 49 Page 50
Image 50
Page 49 Page 50
Contents SmartNode Mailsupport@patton.com Summary Table of Contents Table of Contents Cabling End user license agreement List of Figures List of Tables Structure About this guideAudience Precautions Impaired functioningSafety when working with electricity General observations Typographical conventions used in this document General conventionsChapter contents General informationSmartNode 5200 overview SmartNodeSmartNode 5200 rear panel WAN ETH 0/0SmartNode 5200 front panel LEDApplications overview Introduction Typical applicationSmartNode installation Site log Planning the installationNetwork Diagram Network informationInstalling the gateway router Installing cables Connecting the 10/100Base-T Ethernet LAN and WAN cablesRouter front panel LEDs Initial configuration Connecting the SmartNode to your laptop PC Connecting the SmartNode to your laptop PCLogin Configuring the desired IP addressFactory-default IP settings Changing the WAN IP addressConnecting the SmartNode to the network LANLoading the configuration optional Additional information Contacting Patton for assistance Patton support headquarters in the USA Warranty coverageContact information Out-of-warranty service RMA numbersAppendix a Compliance information CE Declaration of Conformity Low-Voltage Directive SafetyCompliance Authorized European RepresentativeAppendix B Specifications Data connectivity Voice signallingIP services ManagementOperating temperature DimensionsWeight and power dissipation Operating environmentAppendix C Cabling Typical Ethernet straight-through cable diagram EthernetAppendix D Port pin-outs Pin Signal Appendix E SmartNode 5200 factory configuration SmartNode 5200 factory configuration Interface eth1 Authentication Outbound Authenticate Bind interface eth0 router no shutdown Appendix F End user license agreement End User License Agreement Termination Other licenses
Top Page Image Contents