TP-Link TL-WA601G manual Back Panel, System Requirements, Installation Environment Requirements

Page 10

TL-WA601G108M Wireless Access Point User Guide

2.2The Back Panel

Figure 2-2

¾Wireless antenna

¾Factory Default Reset button

¾There are three ways to reset the AP's factory defaults:

•Use the Factory Defaults function on System Tools ->Factory Defaults page in the AP's Web-based Utility.

•Use the Factory Default Reset button: Press and hold the default Reset button for 5 seconds, and then the AP reboot after the System led flash 5 times.

•Use the Factory Default Reset button: First, turn off the AP's power. Second, press and hold the default Reset button then turn on the AP's power, until the system LED lights up (about 3 seconds). Last, release the reset button and wait for the AP to reboot.

)Note:

Ensure the AP is powered on before it restarts completely.

¾One LAN 10/100Mbps RJ45 port for connecting the AP to hub or switch

¾AC power socket: Only use the power adapter provided with the TL-WA601G 108Mbps Wireless Access Point; Usage of a different adapter may result in product damage.

2.3System Requirements

¾Broadband Internet Access Service (DSL/Cable/Ethernet)

¾One DSL/Cable Modem that has an RJ45 connector

¾A Ethernet broadband router

¾TCP/IP protocol must be installed on each PC

¾Web browser, such as Microsoft Internet Explorer 5.0 or later, Netscape Navigator 6.0 or later

¾802.11g or 802.11b-compliant devices, such as the TL-WN510G Wireless Adapter

2.4Installation Environment Requirements

¾Not in direct sunlight or near a heater or heating vent

4

Page 9 Page 11
Image 10
Page 9 Page 11
Contents TL-WA601G Copyright & Trademarks FCC Statement Required Contents Appendix a Glossary Appendix B Specifications Appendix C FAQ Package Contents Introduction Main FeaturesProduct Overview Front Panel Hardware InstallationConventions LED ExplanationBack Panel Installation Environment RequirementsSystem Requirements Connecting the Device Configure PCTL-WA601G108M Wireless Access Point User Guide Configure the IP address manually. Click OK If the connection between your PC and the AP is correct? Software Configuration LoginStatus MAC address, IP address and Subnet MaskWireless NetworkBasic Settings Wireless Mode Wireless Mode Settings TL-WA601G108M Wireless Access Point User Guide TL-WA601G108M Wireless Access Point User Guide TL-WA601G108M Wireless Access Point User Guide Site Survey Security Settings TL-WA601G108M Wireless Access Point User Guide MAC Filtering TL-WA601G14 Add or Modify Wireless MAC Address Filtering entry To modify or delete an existing entryFor example Wireless Statistics DhcpDhcp Settings 17 Dhcp SettingsDhcp Clients List Address ReservationTo modify a Reserved IP address Wireless SettingsTo Reserve IP addresses To delete all Reserved IP addressesSystem Tools FirmwareFactory Defaults 22 Firmware UpgradeBackup & Restore RebootPassword SyslogTL-WA601G108M Wireless Access Point User Guide Appendix a Glossary TL-WA601G108M Wireless Access Point User Guide Wireless Appendix B SpecificationsPhysical and Environment Cannot access the AP with a wireless capable computer Appendix C FAQNo lights are lit on the access point LAN light is not lit
Top Page Image Contents