TP-Link manual TL-WA601G108M Wireless Access Point User Guide

Page 22

TL-WA601G108M Wireless Access Point User Guide

Figure 3-8 Wireless repeating

2.Verify the wireless security parameters for all access points, if any.

3.Verify connectivity across the LANs. A computer on any LAN segment should be able to connect to the Internet or share files and printers with any other PCs or servers connected to any of the three WLAN segments.

)Note:

You can extend this repeating by adding up to 2 additional TL-WA601Gs configured in repeater mode. However, since Repeater configurations communicate in half-duplex mode, the bandwidth decreases as you add Repeaters to the network. Also, you can extend the range of the wireless network with wireless antenna accessories.

¾Bridge (Point to Point) - This mode bridges the AP and another AP also in bridge mode to connect two wired LANs. Please input the MAC address of the other AP in the field of MAC of AP.

•With AP mode: If you select this option, you AP will also support AP mode when it is in Bridge (Point to Point) mode.

Here is an example of how to configure Point-to-Point Bridge. Please do the following:

Figure 3-9 Point to Point Bridge

1.Configure the TL-WA601G (AP1) on LAN Segment 1 in Point-to-Point Bridge mode.

2.Configure the TL-WA601G (AP2) on LAN Segment 2 in Point-to-Point Bridge mode. AP1 must have AP2’s MAC address in its MAC Address field and AP2 must have AP1’s MAC address in its MAC Address field.

3.Configure and verify the following parameters for both access points:

16

Page 21 Page 23
Image 22
Page 21 Page 23
Contents TL-WA601G Copyright & Trademarks FCC Statement Required Contents Appendix a Glossary Appendix B Specifications Appendix C FAQ Package Contents Introduction Main FeaturesProduct Overview Front Panel Hardware InstallationConventions LED ExplanationBack Panel Installation Environment RequirementsSystem Requirements Connecting the Device Configure PCTL-WA601G108M Wireless Access Point User Guide Configure the IP address manually. Click OK If the connection between your PC and the AP is correct? Software Configuration LoginStatus MAC address, IP address and Subnet MaskWireless NetworkBasic Settings Wireless Mode Wireless Mode Settings TL-WA601G108M Wireless Access Point User Guide TL-WA601G108M Wireless Access Point User Guide TL-WA601G108M Wireless Access Point User Guide Site Survey Security Settings TL-WA601G108M Wireless Access Point User Guide MAC Filtering TL-WA601G14 Add or Modify Wireless MAC Address Filtering entry To modify or delete an existing entryFor example Wireless Statistics DhcpDhcp Settings 17 Dhcp SettingsDhcp Clients List Address ReservationTo modify a Reserved IP address Wireless SettingsTo Reserve IP addresses To delete all Reserved IP addressesSystem Tools FirmwareFactory Defaults 22 Firmware UpgradeBackup & Restore RebootPassword SyslogTL-WA601G108M Wireless Access Point User Guide Appendix a Glossary TL-WA601G108M Wireless Access Point User Guide Wireless Appendix B SpecificationsPhysical and Environment Cannot access the AP with a wireless capable computer Appendix C FAQNo lights are lit on the access point LAN light is not lit
Top Page Image Contents