TP-Link TL-WN322G manual Appendix B Specifications, Normal, Interface, Standards, Operating System

Page 37

TL-WN322G54M Wireless USB Adapter User Guide

Appendix B: Specifications

		Normal
	Interface	A-type USB 2.0 Connector
	Standards	IEEE 802.1b; IEEE 802.1g
	Operating System	Windows 98, ME, 2000, XP, 2003, 64bit XP
	Transmission	In door up to 100m, out door up to 300m (It is limited to the
	Distance	environment).
	Radio Data Rate	54/48/36/24/18/12/9/6 Mbps 11g OFDM，11/5.5/3/2/1 Mbps 11b
	Radio Data Rate	DSSS,(Auto Rate Sensing)
		DSSS,(Auto Rate Sensing)

	Modulation	11g OFDM , 11b CCK/DSSS
	Media Access	CSMA/CA with ACK
	Protocol	CSMA/CA with ACK
	Protocol
	Transmit Power	15dBm (Typical)
	Data Security	WPA; 64/128/256 bit WEP; TKIP/AES; IEEE 802.1X authentication
	Frequency	2.4～2.4835 GHz
	Spread Spectrum	Direct Sequence Spread Spectrum (DSSS)
	Safety& Emissions	FCC, CE

		Physical Environmental
	Operating Temp	0℃～55℃ (32℉～104℉)
	Storage Temp	-40℃～70℃(-40℉～158℉)
	Humidity	5%～90% RH, Non-condensing
	Dimensions	3.4×1.0×0.5 inch (85.7×25.9×11.8 mm)
	(W×D×H)	3.4×1.0×0.5 inch (85.7×25.9×11.8 mm)
	(W×D×H)

- 32 -

Image 37

Contents Page All rights reserved COPYRIGHT & TRADEMARKSFCC RF Radiation Exposure Statement FCC STATEMENTIMPORTANT NOTE FCC Radiation Exposure Statement CE Declaration of Conformity¾ EN 301 489-1 V.1.4.1 2002 / EN 301 489-17 V.1.2.1 ¾ EN 60950-1 ¾ EN 300 328 V.1.4.1Chapter TL-WN322G 54M Wireless USB Adapter User Guide Package Contentsy Drivers and Utility LED Indicator 1.1 FeaturesChapter 1 Introduction 1.2 LED StatusAd-hoc peer-to-peer Mode 1.4 Network ConfigurationInfrastructure Mode Figure 1-2 Infrastructure mode 2.2 Installing the Drivers Chapter 2 Installation Guide2.1 Before You Begin Figure 2-3 Install Shield-Setup Status Figure 2-2 Install Shield-Choose Destination Location¾ Wait a few moments until the files are copied to the computer Figure 2-4 Installation Complete 1. Click on Start Settings Control Panel Add or Remove Programs Chapter 3 Uninstall Guide3.1 Through Control Panel 3.2 Through Programs TL-WN322G Wireless UtilityFigure 3-6 Uninstalling TL-WN322G Wireless Utility and the drivers Figure 3-5 Confirm the Uninstalling processFigure 3-7 Uninstalling process finished 4.1 Station Mode Configuration Chapter 4 Software Configuration4.1.1.1 General Connection Setting ¾ Current Network Information¾ You can click “Change” button to change general connection settings Figure 4-2 More settingFigure 4-3 More setting-Click Change Figure 4-4 More setting-WEP 4.1.1.2 WEP Encryption 4.1.1.3 WPA/WPA2 Authentication with TKIP/AES Encryption ¾ Click on the WPA Encryption Setting button Figure 4-8 WPA setting ¾ Protocol Select TLS from the drop-down list 4.1.1.5 Profiles 4.1.1.4 WPA-PSK Authentication4.1.1.6 Advanced Settings 4.2 Wireless network mode configuration Figure 4-15 Access point setting Chapter 5 Examples for application 5.1 Configuration of WEP EncryptionStep 6 ： Step 3：ClickStep There is two parts of this setting： 5.2 Configuration of PSP ModePart 1：Configuration of our TL-WN322G 54M Wireless USB Adapter Step One： Select “Access Point” from the drop down listRemark Step Six：Select address settings mode-Easy Step Ten： Select ”Test Connection” Step Nine： ”Proxy Server” select ”Do Not Use”Appendix A Glossary ¾ RADIUS- Remote Authentication Dial In User Service ¾ PEAP- Protected Extended Authentication Protocol¾ PSK- Pre-Shared Key ¾ TKIP- Temporal Key Integrity Protocol ¾ AES- Advanced Encryption Standard ¾ TLS- Transport Layer SecurityMedia Access Appendix B SpecificationsTransmit Power Safety& EmissionsAppendix C Contact Information