Configuration Guide
CLI Commands to Set Up Subnet Roaming
Commands for the master switch (the Aruba 800)
Configure terminal
ip | of router> | ||
ap | location 1.1.0 | (#ap | connected to 800) |
ap location 1.2.0 (#ap connected to 6000)
ip route 224.0.0.0 255.0.0.0 <ip_addr of SpectraLink gateway>
exit write mem
Commands for the local switch (the Aruba 6000)
The AP’s IP address must be on the same subnet as the switch.
Configure terminal
masterip <ip address of the master > interface loopback
ip address <ip_addr of the 6000>
vlan 1 interface vlan 1
ip address <ip_addr of the 6000> <netmask> interface fastethernet <port>
switchport access vlan 1 | (only if the port is an |
| access port) |
trusted |
|
no shut |
|
!
ip
!
exit write mem
After the master switch IP address and the local switch IP address are configured on the local switch, the switch needs to be rebooted prior to use.
28 | PN: |