TP-Link TL-PA250 manual Hardware Connection Computer, Hardware Connection Internet

Page 10

TL-PA250AV200+ Powerline Adapter with AC Pass Through

2.3 Hardware Connection – Computer

For those computers you wish to be networked by Powerline Adapter, each of the computers must be properly connected with a Powerline Adapter through an Ethernet (RJ-45) cable.

Following are the steps to properly connect the Powerline Adapter to your computer:

1．Connect one end of the provided Ethernet (RJ-45) cable to the Powerline Adapter’s Ethernet port.

2．Connect the other end of the Ethernet (RJ-45) cable to you computer’s LAN port.

3．Plug the Powerline Adapter into a wall socket next to the computer.

4．Turn on your computer.

5．Check and confirm that the Power LED and Ethernet LED on the Powerline Adapter are ON.

The hardware connection mechanism is shown below:

)Note:

Do not connect the Powerline adapter to any extension lead, power strip, extension cord or surge protector, as these may degrade the network performance.

2.4 Hardware Connection – Internet

This section describes how to connect the Powerline Adapter into your existing ADSL broadband connection via ADSL Ethernet port. Follow the procedures described below to connect the Powerline Adapter to your ADSL broadband connection:

1．Connect one end of the provided Ethernet (RJ-45) cable to the Powerline Adapter’s Ethernet port.

2．Connect the other end of the Ethernet (RJ-45) cable to an available Ethernet port of your ADSL broadband Router.

3．Plug the Powerline Adapter into a wall socket next to the computer.

4．Turn on your computer.

5．Check and confirm that the Power LED , Ethernet LED , and Powerline LED Powerline Adapter are ON.

The hardware connection mechanism is shown below:

on the

5

Page 9 Page 11
Image 10
Page 9 Page 11
Contents TL-PA250 Copyright & Trademarks FCC Statement Important Safety Instructions Contents Introduction Package ContentsSystem Requirement LED Indicator Status IndicationPhysical Interface Interface DescriptionConnecting Mechanism Connection InstructionHardware Connection Computer Hardware Connection InternetTL-PA250AV200+ Powerline Adapter with AC Pass Through Installing Management Utility TL-PA250AV200+ Powerline Adapter with AC Pass Through TL-PA250AV200+ Powerline Adapter with AC Pass Through TL-PA250AV200+ Powerline Adapter with AC Pass Through Using the Management Utility MainTL-PA250AV200+ Powerline Adapter with AC Pass Through To upgrade the devices firmware, follow these instructions RenameEnter Password Add Device Reset Privacy Diagnostics TL-PA250AV200+ Powerline Adapter with AC Pass Through About Create a secured Powerline network using the Pair button： Advanced Feature How to Use the Pair ButtonsSet Up a Secured Powerline AV Network with the Pair Button Pair Secure with 128 bits-AESJoin an existing secured Powerline AV Network Leave an existing secured Powerline AV NetworkPowerline LED does not light up Appendix a Troubleshooting GuidePower LED does not light up. Ans. Check the following Ethernet LED does not light up. Ans. Check the followingGeneral Appendix B SpecificationsPhysical and Environment
Top Page Image Contents