TP-Link TD-W8960N manual Panel Layout, Front Panel, LED Explanation Name Status Indication

TD-W8960N300Mbps Wireless N ADSL2+ Modem Router User Guide

1.3 Panel Layout

1.3.1 The Front Panel

The Router’s LEDs are located on the front panel.

Figure 1-1

The Router’s LEDs and the QSS button are located on the front panel (View from left to right).

LED Explanation:

Name	Status		Indication
	On		The modem router is powered on.
Power
	Off	The modem router is off. Please ensure that the power adapter is
		connected correctly.
	On		The network is available with a successful Internet connection.
Internet	Flash	There is data being transmitted or received via the Internet.
	Off	There is no successful Internet connection or the modem router is
		operating in Bridge mode. Please refer to Note 2 for troubleshooting.
	On		ADSL line is synchronized and ready to use.
ADSL
	Flash		The ADSL negotiation is in progress.
	Off	ADSL synchronization fails. Please refer to Note 1 for troubleshooting.
	On		Wireless is enabled but no data is being transmitted.
WLAN	Flash		The modem router is sending or receiving data over the wireless
			network.
	Off	Wireless function is disabled.
	On		There is a device connected to this LAN port.
LAN 1,2,3,4
	Flash		The modem router is sending or receiving data over this LAN port.
	Off	There is no device connected to this LAN port.
	On		A wireless device has been successfully added to the network by QSS
			function.
			QSS handshaking is in process and will continue for about 2 minutes.
QSS	Flash		Please press the QSS button on other wireless devices that you want
			to add to the network while the LED is flashing.
		The QSS function is disabled or the wireless device fails to be added
	Off	to the network in 2 minutes after QSS function is enabled. Please refer
		to 4.5.2.1 QSS (WPS) Setup for more information.

4