TP-Link TD-W8960N manual MAC Filtering

TD-W8960N300Mbps Wireless N ADSL2+ Modem Router User Guide

Figure 4-34

2.Enter the Filter name for the rule, it is exclusive and must be filled in.

3.Select Protocol in the drop-down list, enter Source IP address, Source Subnet Mask, Source Port, Destination IP address, Destination Subnet Mask, and Destination Port for the rule.

4.Select at least one WAN interfaces displayed below to apply this rule.

5.Click Save/Apply to save this entry.

)Note:

When you add an Incoming IP Filtering entry, you must configure at least one condition on the preceding screen except the Filter name. If you leave Protocol blank, it means that the rule is effective to all protocols, if you leave the Source IP address and/or Destination IP address blank, it suggests that all Source IP addresses and/or Destination IP addresses are controlled by the rule, if you leave the Source Port and/or Destination Port blank, it suggests that all Source Ports and/or Destination Ports are controlled by the rule.

4.4.6.2 MAC Filtering

Choose “Advanced Setup”Æ“Security”Æ“MAC Filtering”, you can configure MAC Filtering rules on the screen as shown in Figure 4-35.The section allows you to control access to the Internet by users on your local network based on their MAC Address.

)Note:

MAC Filtering is only effective on ATM PVC(s) configured in Bridging mode.

43