Gigabit Uplink Unmanaged Switch
2.4 Product Installation
■■ Desktop Installation
To install the device on the desktop, please follow the steps:
111Set the device on a flat surface strong enough to support the entire weight of the device with all fittings.
222Remove the adhesive backing papers from the rubber feet.
333Turnover the device and attach the supplied rubber feet to the recessed areas on the bottom at each corner of the device.
Feet
Bottom of the Device
Notch
Figure 2-1 Desktop Installation
■■ Rack Installation
To install the device in an EIA
111Check the grounding and stability of the rack.
222Secure the supplied
Screw
Figure 2-2 Bracket Installation
333After the brackets are attached to the device, use suitable screws (not provided) to secure the brackets to the rack, as illustrated in the following figure.
Installation 
07